Inside the appliance
Interior light and door switch. In plain English.
The interior light is controlled by the display light key and a door switch. Electrolux lists two troubleshooting cases: no light, which points to a failed LED assembly, and a light that will not go out, which is the manual light control or a door switch not making contact.

Where it fits.
Interior light and door switch in the appliance
The guide names an LED assembly and a door switch but gives no position.
The image shows the type of component only. It does not select a replacement that fits your model.
What is different once this system needs attention.
Interior light and door switch concerns may show up with a drop in performance or a code that keeps returning. Testing comes first before anyone decides the component has failed.

Electrolux wine cooler not cold enough
The Electrolux guide gives four reasons for a cabinet that stays warm: a control set warmer than needed, an interior light left on, a front grille with no airflow, or a leaking door gasket. Allow a day after any change.

Electrolux wine cooler interior light problems
If the light is out, the guide names a failed LED assembly. If it will not go out with the door closed, the manual light control may be on or the door switch may not be making contact. Check door alignment first.
Owner care, within the model instructions.
Power the appliance down and pull the plug before any owner check. Beware of standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or step beyond your model’s owner guide.
- 1
Check the manual light
The display light key cycles off, low and maximum. The light turns itself off after 120 minutes.
- 2
Close the door
If the light stays on with the door shut, the guide lists the manual control, or a door switch that is not making contact, and says to check door alignment (p.16).
- 3
No light at all
The guide lists a failed LED assembly and says to contact a qualified technician.
- 4
Cabinet temperature
A light left on appears in the not-cold-enough list, and the guide says light time mainly affects the top racks.
Cleaning or replacement?
Leave internal testing to a technician.
Book a technician if the light is dead, or stays on with the door closed and the manual control off.
Arrange a diagnosticSources and model boundaries.
These sources back the Interior light and door switch guidance. Use the manual for your own model.
- Use & Care Guide, Wine Cooler / Beverage Center (241888400)
- Wine Cooler / Beverage Center Use and Care Guide (A16345301)
Follow the guide for your exact model. Consult how we research these pages.
Why is my wine cooler light on with the door shut?
The manual light control may be on, or the door switch is not making contact.
Why is there no interior light?
The guide lists a failed LED assembly and says to contact a qualified technician.
Does the light turn itself off?
Yes, after 120 minutes. You can turn it on again by hand.
Can the light affect temperature?
It can. The guide says light time mainly warms wine or drinks on the top racks.
Codes, symptoms, parts and service
Link the message to what to do next.
Electrolux wine cooler not cold enough
The Electrolux guide gives four reasons for a cabinet that stays warm: a control set warmer than needed, an interior light left on, a front grille with no airflow, or a leaking door gasket. Allow a day after any change.
Wine cooler repair
Book a diagnostic for your model at the appliance.
Find your metro
Office details and the access information to pass on.

