Inside the appliance
Beverage center glass shelf. In plain English.
The glass shelves in an Electrolux beverage center sit above two bottle racks. The 2007 guide shows two ways out: lift the whole assembly off its ladder, or extend the shelf and release the slide latches. The 2019 guide has you remove fixing screws on both sides.

Where it fits.
Beverage center glass shelf in the appliance
The shelves are above the two lower bottle racks inside the cabinet.
The image shows the type of component only. It does not select a replacement that fits your model.
What is different once this system needs attention.
Beverage center glass shelf concerns may show up with a drop in performance or a code that keeps returning. Testing comes first before anyone decides the component has failed.

Electrolux beverage center HI alarm
When a beverage center is too warm, the display blinks HI, the alarm sounds and the high temp indicator flashes. Press mute sounds to silence it. HI stays lit until the unit reaches a safe temperature, which can take 24 hours.

Electrolux beverage center too cold or freezing
A beverage center that is too cold, or whose contents are frozen, usually has the control set too cold. The guide says to adjust the temperature warmer and allow 24 hours to stabilize before judging the new setting.
Owner care, within the model instructions.
Power the appliance down and pull the plug before any owner check. Beware of standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or step beyond your model’s owner guide.
- 1
Method 1: whole shelf
Open the door fully, lift the front edge and rear of the shelf so the cantilever brackets disengage from the ladder.
- 2
Method 2: glass only
Extend the shelf, push the plastic release latches on each side and pull the glass out.
- 3
Refit with care
Make sure the cantilever brackets seat in the proper holes, or push the slides in fully so each side engages.
- 4
Newer guide differs
The 2019 guide says to open the door, remove the fixing screws on both sides of the shelf and keep pulling it out; empty it first and use both hands (p.20).
Cleaning or replacement?
Leave internal testing to a technician.
Book a technician if a shelf bracket is broken or the glass shelf will not seat.
Arrange a diagnosticSources and model boundaries.
These sources back the Beverage center glass shelf guidance. Use the manual for your own model.
- Use & Care Guide, Wine Cooler / Beverage Center (241888400)
- Wine Cooler / Beverage Center Use and Care Guide (A16345301)
Follow the guide for your exact model. Consult how we research these pages.
How do I take out a glass shelf?
Lift the shelf off its ladder, or extend it and push the latches on each slide, then pull.
Does every model use the same method?
No. The 2007 guide uses brackets and slide latches; the 2019 guide removes fixing screws. Use the guide for your own model.
How many bottles fit?
Eight on the two lower racks, plus the glass shelves above.
Do wine coolers have glass shelves?
No, the guide marks the glass shelf steps for the beverage center only.
Codes, symptoms, parts and service
Link the message to what to do next.
Electrolux beverage center HI alarm
When a beverage center is too warm, the display blinks HI, the alarm sounds and the high temp indicator flashes. Press mute sounds to silence it. HI stays lit until the unit reaches a safe temperature, which can take 24 hours.
Beverage center repair
Book a diagnostic for your model at the appliance.
Find your metro
Office details and the access information to pass on.

