Before work starts
The technician examines the appliance, tells you what the repair involves and agrees the cost with you before opening anything up.
Independent appliance repair
We repair Electrolux beverage centers, the glass-shelf undercounter coolers for bottles and cans: a unit that runs warm, a display showing HI or LOC, an alarm that keeps repeating, a light that stays lit. Quote the model, then arrange a technician visit.


When a beverage center is too warm, the display blinks HI, the alarm sounds and the high temp indicator flashes. Press mute sounds to silence it. HI stays lit until the unit reaches a safe temperature, which can take 24 hours.

A beverage center that is too cold, or whose contents are frozen, usually has the control set too cold. The guide says to adjust the temperature warmer and allow 24 hours to stabilize before judging the new setting.
No further researched dishwasher code is tied to this topic. Match the exact message to your model manual and do not swap in another code from the library.
See the research statusThe guides name few beverage center parts, so none are listed. Once your unit has been diagnosed, we check the part for your exact model and only fit it after you approve.

This component has no illustrated glossary entry here. Rely on the system named in the explanation and the cited model manual; a code alone does not name a replacement.
Explore the researched partsHow a repair visit runs.
Measured and clear.

Name the washer, dryer or oven and say what it does. Add the code on the screen if there is one.

The technician runs the cycle, checks the parts behind the code and explains the cost before starting.

The part is replaced, a test cycle confirms the fix, and the technician walks you through the result.
On the 2007 guide's beverage center, a high temperature condition sounds an alarm and shows HI until a safe temperature returns. Pressing the mute sounds key only silences the horn.
Holding the mute sounds key for 3 seconds turns on control lock and shows LOC. The on/off key set to OFF shows OFF but leaves the unit connected to power, so the cabinet is not cold.
Pressing vacation mode switches off the interior lights and keypad inputs to save energy. A dark cabinet that ignores the keypad may simply be in that mode.
Glass shelves come out either as a whole assembly or on their ball-bearing slides once the plastic latches are released. The 2019 model first needs the retaining screws at each side taken out. Empty a shelf before moving it.
The 2007 beverage center holds 8 bottles on two lower racks, with more room on the glass shelves above. The guide ties inside temperature to the setting, room heat, door openings and direct sunlight.
In the 2019 guide, mute sounds plus light, held 10 seconds, toggles demo mode on the beverage center. A cabinet that acts like a showroom unit may have had that sequence pressed by accident.
HI comes back after a day of sensible settings and a closed door.
The cabinet is warm 24 hours after a correct setting, although the grille has room and the door seals.
The alarm keeps repeating after you acknowledge it.
A shelf slide catches, or the door still won't shut after realigning.
Wiring and the sealed system are for the technician. Switch power off at the outlet before cleaning.
Arrange a diagnosticThe technician examines the appliance, tells you what the repair involves and agrees the cost with you before opening anything up.
An Electrolux still under its manufacturer warranty goes to Electrolux for covered repairs. Our repairs carry a warranty on our workmanship.
They share a cabinet and a guide, but the beverage center has glass shelves and a HI alarm and no cellar mode. Pick this page if your unit stores cans and bottles.
HI on the 2007 beverage center marks a high temperature alarm. On the 2019 platform a high temperature held for 6 hours shows Hº. Both clear once a safe temperature is back.
Press the mute sounds key, which acknowledges the alarm and stops the horn. The indicator keeps blinking until the cause is fixed, so a repeat alarm needs a technician.
Yes, after emptying them. The guide describes lifting the whole shelf assembly or releasing the slide latches. Use both hands and never move a loaded shelf.
No. Within the manufacturer's warranty the manufacturer handles that repair. After that, or by choice, book us and approve the price first.
Codes, symptoms, parts and service
When a beverage center is too warm, the display blinks HI, the alarm sounds and the high temp indicator flashes. Press mute sounds to silence it. HI stays lit until the unit reaches a safe temperature, which can take 24 hours.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.