What it means
H° flashing with the alert icon tells you the beverage center has sat above its set temperature for six hours. Look at the door seal, the front grille and the lamp mode, rearrange the load if it is crowded, and give the cabinet a day.
Electrolux beverage center H° / Temperature and alarms
H° flashing with the alert icon tells you the beverage center has sat above its set temperature for six hours. Look at the door seal, the front grille and the lamp mode, rearrange the load if it is crowded, and give the cabinet a day.
Also shown as H°
H° flashing with the alert icon tells you the beverage center has sat above its set temperature for six hours. Look at the door seal, the front grille and the lamp mode, rearrange the load if it is crowded, and give the cabinet a day.
A door that sits crooked or lets air past the gasket is on Electrolux's list of causes for poor cooling.
H° returns once the door, grille and set point are right.
Your checklist, kept on this device

A door that sits crooked or lets air past the gasket is on Electrolux's list of causes for poor cooling.

Nothing should obstruct airflow to the front grille.

The troubleshooting table counts a lamp left on among the causes.
Lower the set point and allow 24 hours.
Send us the model and the checks you have done, and open your request here.
Book a visitA simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
Six hours above the set temperature. H° then replaces the reading and the alert icon blinks.
Read the supporting manualThe list reads: set point too warm, lamp left on, front grille blocked, gasket leaking air.
Read the supporting manualNo. The mode lets this one through: a steady icon, plus a buzzer that quits on its own after ten minutes.
Read the supporting manualManufacturer document
Electrolux (document served from the sister brand's asset library)
June 2019 / PDF p.17 (Operation, High / Low temperature alert)
Manufacturer document
Electrolux (document served from the sister brand's asset library)
June 2019 / PDF p.22 (Troubleshooting)
Electrolux beverage center panel, A16345301 guide (June 2019).
It is described as an alert rather than a sensor failure.
Yes, if the door was left open long enough to warm the cabinet. One needs five minutes, the other six hours of warmth.
The guide advises against filling the cabinet to the brim.
If door, grille and gasket are all fine, the cooling system is the next suspect and belongs to a technician.
Codes, symptoms, parts and service
When L° sits beside a blinking alert icon, the beverage center is warning that it ran cold. For six hours the cabinet ran cooler than the set temperature. Raise the setting a step and let the cabinet settle for a full day.
When a beverage center is too warm, the display blinks HI, the alarm sounds and the high temp indicator flashes. Press mute sounds to silence it. HI stays lit until the unit reaches a safe temperature, which can take 24 hours.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.