What it means
When L° sits beside a blinking alert icon, the beverage center is warning that it ran cold. For six hours the cabinet ran cooler than the set temperature. Raise the setting a step and let the cabinet settle for a full day.
Electrolux beverage center L° / Temperature and alarms
When L° sits beside a blinking alert icon, the beverage center is warning that it ran cold. For six hours the cabinet ran cooler than the set temperature. Raise the setting a step and let the cabinet settle for a full day.
Also shown as L°
When L° sits beside a blinking alert icon, the beverage center is warning that it ran cold. For six hours the cabinet ran cooler than the set temperature. Raise the setting a step and let the cabinet settle for a full day.
The troubleshooting table lists a control set too cold for contents that are too cold or frozen.
L° persists through a warmer setting and a day of waiting.
Your checklist, kept on this device

The troubleshooting table lists a control set too cold for contents that are too cold or frozen.

Move warmer and allow 24 hours to stabilize.

The table mentions frozen contents, so check cans and bottles for that.
L° should give way to the normal reading as the cabinet recovers.
Send us the model and the checks you have done, and open your request here.
Book a visitA simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
The temperature has been cooler than set for six hours, and the alert icon blinks.
Read the supporting manualUnder too-cold or frozen contents the cause given is a control set too cold; the remedy is a warmer setting and a day of patience.
Read the supporting manualNo. Cold and warm alerts survive the mode, though the sound lasts only ten minutes while the icon stays.
Read the supporting manualManufacturer document
Electrolux (document served from the sister brand's asset library)
June 2019 / PDF p.17 (Operation, High / Low temperature alert)
Manufacturer document
Electrolux (document served from the sister brand's asset library)
June 2019 / PDF p.22 (Troubleshooting)
Electrolux beverage center panel, A16345301 guide (June 2019).
Electrolux frames it as an alert tied to the set point.
The table does describe frozen contents when the setting is too cold.
They are opposites on the same six-hour rule.
Give it a day, then ask a technician to check the cooling controls.
Codes, symptoms, parts and service
H° flashing with the alert icon tells you the beverage center has sat above its set temperature for six hours. Look at the door seal, the front grille and the lamp mode, rearrange the load if it is crowded, and give the cabinet a day.
When a beverage center is too warm, the display blinks HI, the alarm sounds and the high temp indicator flashes. Press mute sounds to silence it. HI stays lit until the unit reaches a safe temperature, which can take 24 hours.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.