Inside the appliance

Ice chute and auger. In plain English.

The ice chute carries cubes from the bin to the dispenser in the door, and the auger in the bin pushes them forward. Electrolux’s DI SP alarm means a cube has sat in the chute too long. A second article covers ice that has melted and refrozen around the auger motor shaft.

Last reviewed

Arm reaching into the frosty ice chute opening behind a refrigerator ice bin full of cubes, with a few cubes stuck at the opening
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Where it fits.

Ice chute and auger in the appliance

The articles name the chute, the ice bin and the auger motor shaft but give no further position. The chute ends at the dispenser, and the paddle you press sits there.

The image shows the type of component only. It does not select a replacement that fits your model.

Owner care, within the model instructions.

Power the appliance down and pull the plug before any owner check. Beware of standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or step beyond your model’s owner guide.

  1. 1

    Look into the chute

    Open the door, look into the chute and take out anything stuck there. KB 1853035 gives this as the whole answer to DI SP.

  2. 2

    Thaw and empty the bin

    For DI SP the article has you take out the ice bin, let it thaw, empty and dry it, clean it and set it back. New ice should then reach the dispenser.

  3. 3

    Melt the ice at the auger

    Set the panel to crushed, take out the bin, hold the paddle for 2 minutes, release, and repeat for three rounds. Then set cubed, refit the bin and test (KB 1898311).

  4. 4

    Clear the alert

    Depending on the model, press Clear Alerts or unplug the refrigerator for half a minute. The article says a breaker reset also works, but it resets everything on that circuit.

Cleaning or replacement?

Leave internal testing to a technician.

Book a technician if DI SP returns after the bin is thawed and the chute is clear.

Book a technician if ice still does not come out after the three paddle rounds.

Arrange a diagnostic

Sources and model boundaries.

These sources back the Ice chute and auger guidance. Use the manual for your own model.

  • What do the alarms or error messages mean on my French-Door refrigerator? (KB 1853035)
  • Refrigerator Error Code DI SP or DISP - Ice Jam (KB DI SP)
  • Refrigerators - Auger Fix (KB 1898311)

Follow the guide for your exact model. Consult how we research these pages.

Here to help

Good questions.
Clear answers.

Talk to our team
What does DI SP mean on an Electrolux refrigerator?

It means an ice cube has been stuck in the chute for a long time. An alarm sounds. Electrolux says to open the door, look down the chute and clear whatever is stuck.

Why would ice freeze around the auger?

The DI SP article blames rare use, temperature swings and power outages, which let ice thaw and re-ice around the auger. Cubes can also lodge where the ice maker meets the bin.

How long do I hold the paddle in the auger fix?

Two minutes at a time, released between rounds, three rounds in total (6 minutes). The article says this melts and evaporates ice around the auger motor shaft.

Why switch between crushed and cubed?

The fix starts with the panel on crushed and finishes on cubed before you test. Electrolux gives no further reason, so follow the order as printed.

Let’s take care of it.

Premium appliances deserve
careful service.