Using your appliance

Electrolux refrigerator alarms: PF, High Temp, Door Ajar, Sb and DI SP

Most Electrolux refrigerator alarms are prompts: PF after a power cut, High Temp when a section passes 26 degrees (freezer) or 55 degrees (fridge), Door Ajar after 5 minutes open, Sb for Sabbath mode and DI SP for an ice jam. OP, SH, SY CE, SY CF and SY EF have no printed meaning.

Stainless French-door refrigerator with one door open showing food shelves and a small lit display on the other door.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work
On this page
Key points
  • High Temp triggers at 26 degrees in the freezer and 55 in the refrigerator. 1
  • A door left open for 5 minutes sets off Door Ajar. 1
  • Recommended settings in a kitchen: 37 degrees refrigerator, 0 degrees freezer. 2
  • Sabbath mode survives a power failure and switches off lights, dispenser and panel. 3
  • OP, SH, SY CE, SY CF and SY EF come with no meaning. 1

What do the common alarms on an Electrolux refrigerator mean?#

PF is a power failure to acknowledge. High Temp (H or HI) means a section passed its temperature threshold. A door left open 5 minutes sets off Door Ajar. Sb means Sabbath mode, and DI SP means ice is jammed in the chute. Most are prompts, not breakdowns. 1

Electrolux's alarm article covers French-door, side-by-side and top-freezer models, and adds that models differ, so your own Owner's Manual comes first. 1

DisplayMeaningAction
PFPower failureAfter power returns, press Alarm Reset; it then resumes normal operation 1
H, HI or High TempA section is over its thresholdClose doors, check settings and the seal; press Clear Alerts, or reset if the model needs it 12
Door AjarA door left open 5 minutesShut it, then press Set to clear the alarms 1
Sb or SB SBSabbath modeTurn it off at the control panel 13
DI SPIce jammed in the chuteOpen the door and remove the blockage 14

What triggers the High Temp alarm?#

The freezer reaching 26 degrees Fahrenheit, or the refrigerator section reaching 55. It is usually caused by a door not closed all the way or left open too long. You can mute it, but it stays active, or lit, until the temperature returns to normal. 1

Electrolux's separate H or HI article adds detail. The alarm sounds every 60 seconds, and the highest temperature reached is shown when you first acknowledge it with the Clear Alerts button. 2

The article names three causes:

  • A door left open for an extended time. 2
  • Changed temperature settings. For a kitchen the suggested settings are 37 degrees Fahrenheit in the fridge and 0 in the freezer. 2
  • A poor seal. Check the gasket around the doors for a good seal. 2

A long outage can leave High Temp sounding until the cabinet is back to a safe operating temperature. That is part of the PF story rather than a separate problem. 1

  1. 1

    Close both doors firmly#

    A door left open or not fully shut is the usual cause. 1

    Fingertip tracing the gray gasket around the edge of an open stainless refrigerator door.
  2. 2

    Check the set temperatures#

    The recommended kitchen settings are 37 degrees Fahrenheit (refrigerator) and 0 (freezer). 2

    Control display with a few lit dots and a row of buttons set into a stainless refrigerator door.
  3. 3

    Look at the door gasket#

    Electrolux asks for a good seal all the way around. 2

  4. 4

    Acknowledge the alarm#

    Press Clear Alerts, or the equivalent on your model. The alarm will stay lit until the temperature is normal. 12

If clearing the alarm does not work#

Depending on your model, the Owner Center says to try one of three resets: press Clear Alerts, pull the plug for 30 seconds and then restore it, or use the breaker when the plug is out of reach. A breaker flip also cuts power to everything else on that circuit. 2

How do I turn off Sabbath mode?#

Hold the minus button together with the Temp F-C button for five seconds. The display shows Sb while the mode is on. While it is on, the lights, the dispenser and the control panel do not work, and it persists through a power cut until you switch it off at the panel. 3

The Owner Center explains the design: in Sabbath mode the High Temp alarm stays active for health reasons, and it triggers when the cabinet temperature is outside the safe zone for 20 minutes. The alarm silences itself after 10 minutes, while the High Temp icon stays lit until Sabbath mode ends. 3

That is the reason an Sb refrigerator may still alarm if a door is left open. The keys named here are from the Owner Center article; your model may differ, so your Owner's Manual comes first. 13

What does DI SP mean?#

DI SP means ice cubes are jammed in the ice chute and an alarm sounds when a cube is stuck too long. Open the door and look in the chute, then remove the blockage. If ice has frozen around the auger, remove the ice bin, thaw and empty it, clean it, dry it and put it back. 14

Electrolux lists three reasons: ice melted and froze around the auger from infrequent use, temperature changes or power outages; cubes caught between the ice maker and the back of the bin; or a cube stuck in the chute. When new ice is made, the dispenser should work again. 4

If a refrigerator will not dispense at all and no alarm is showing, Electrolux's no-water article starts elsewhere: power, water supply to the unit, a locked display (hold the Lock key three seconds), and the filter being installed correctly. 5

Open refrigerator ice bin with several ice cubes stuck at the chute opening above the bin.
DI SP points at the chute and the bin first.

What about OP, SH, SY CE, SY CF and SY EF?#

Electrolux prints no meaning for them. The alarm article lists them in a block after the alarms it explains, with only the note that these codes may indicate service is needed. We do not guess a cause and we do not list an owner fix, because the source has none. 1

What is useful is what to write down. If one of those codes stays on after you have closed the doors, checked the settings and tried the reset the Owner Center describes, note the exact characters, whether there was a power cut, and what the temperature display shows. 12

Our page on refrigerator service and unlisted codes is the code-by-code companion to this section.

When does an alarm need a technician?#

Book when one of the service codes stays on, when High Temp returns with the doors shut, the gaskets sealing and the settings at 37 and 0, when Sb will not turn off with the key press, or when DI SP returns right after you clear the chute. A technician can test the sensing and the ice system. 1234

Next step: \book a visit\, or look over our refrigerator service. The technician agrees the price with you before any work starts. The exact cost is confirmed after the on-site diagnostic. If your unit is under the manufacturer's warranty, the manufacturer handles that repair. We give a warranty on our workmanship.

Sources#

  1. What do the alarms or error messages mean on my French-Door refrigerator? (KB 1853035)Electrolux / Owner Center knowledge base (owner.electrolux.com) · Owner Center article, cached 10.11.2026 (no edition date printed) · article text
  2. Refrigerator Error Code H or HI - High Temperature (KB 1917064)Electrolux / Owner Center knowledge base (owner.electrolux.com) · Owner Center article, cached 10.11.2026 (no edition date printed) · article text
  3. Refrigerator Error Code SB SB - Sabbath ModeElectrolux / Owner Center knowledge base (owner.electrolux.com) · Owner Center article, cached 10.11.2026 (no edition date printed) · article text
  4. Refrigerator Error Code DI SP or DISP - Ice JamElectrolux / Owner Center knowledge base (owner.electrolux.com) · Owner Center article, cached 10.11.2026 (no edition date printed) · article text
  5. Refrigerators - No Water (KB 1900025)Electrolux / Owner Center knowledge base (owner.electrolux.com) · Owner Center article, cached 10.11.2026 (no edition date printed) · article text

Here to help

Good questions.
Clear answers.

Talk to our team
At what temperature does the High Temp alarm start?

When the freezer hits 26 degrees Fahrenheit, or the refrigerator section hits 55. You can mute it, but it stays active until the temperature returns to normal. [1]

What temperatures does Electrolux recommend?

In a kitchen: refrigerator at 37 degrees Fahrenheit, freezer at 0. A changed setting can trigger the High Temp alarm. [2]

What is Sb on the display, and why does nothing respond?

The refrigerator is in Sabbath mode. While it is on, the lights, dispenser and control panel do not work, and the mode survives a power cut. Hold the minus button with the Temp F-C button for five seconds to turn it off. [3]

Is DI SP a failure?

No. It means ice cubes are jammed in the ice chute. Open the door and clear the chute. If ice has frozen at the auger, the Owner Center says to take the bin out and thaw it. [1][4]

What do OP, SH, SY CE, SY CF and SY EF mean?

Electrolux prints no meaning. It files them together as codes that may need service. We cannot tell you the cause, and we will not guess one. Book a visit if one stays on. [1]

Let’s take care of it.

Premium appliances deserve
careful service.