What it means
CL, also printed Cd, tells you the dishwasher door is not closed and latched. Nothing has broken yet. Shove the door fully shut and the code vanishes. A code that clings on with the door shut is a latch matter for a technician.
Electrolux dishwasher CL / Mode, not a failure
CL, also printed Cd, tells you the dishwasher door is not closed and latched. Nothing has broken yet. Shove the door fully shut and the code vanishes. A code that clings on with the door shut is a latch matter for a technician.
Also shown as CL
CL, also printed Cd, tells you the dishwasher door is not closed and latched. Nothing has broken yet. Shove the door fully shut and the code vanishes. A code that clings on with the door shut is a latch matter for a technician.
The article says to check that the door is completely closed.
CL stays on with the door fully shut and nothing in the way.
Your checklist, kept on this device

The article says to check that the door is completely closed.

A rack, a utensil handle or a loose bottle can keep the door from latching.

A click means the door is latched. If you hear none, open and close it again.

The code turns off once the door is closed.
Send us the model and the checks you have done, and open your request here.
Book a visitA simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
The door is not closed and latched. Cd is the same message in a different form.
Read the supporting manualClose the door completely and the code goes out. The article lists no other step.
Read the supporting manualThen the latch or door switch may not be registering. Electrolux stops at closing the door, so this is where a technician takes over.
Read the supporting manualManufacturer document
Electrolux / Owner Center knowledge base (owner.electrolux.com)
Owner Center article, fetched 13.11.2026 (no edition date printed) / Article text
Electrolux Owner Center article 1830354 (Dishwashers).
It plays the same role. Electrolux calls it CL or Cd.
No. The cycle needs the door latched.
A rack pushed too far back or a tall item can stop the door closing.
No. The latch is a safety part and should not be bypassed.
Codes, symptoms, parts and service
PF reports that the dishwasher lost power mid-cycle or while waiting. The message is about the interruption, not a failed part. Press START/Cancel to clear it, then begin a new cycle.
Flashing lights and display codes on an Electrolux dishwasher are not always a breakdown. A delay countdown (01-24) and a heat delay (Hd or HO) are normal waiting states, while i20 and i40 point to draining and a clogged filter or sump.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.