What it means
Hd, also written HO, stands for Heat Delay or Heater On. The dishwasher pauses to bring its water up to temperature before washing, which is ordinary behavior. Colder supply water stretches the pause.
Electrolux dishwasher Hd / Mode, not a failure
Hd, also written HO, stands for Heat Delay or Heater On. The dishwasher pauses to bring its water up to temperature before washing, which is ordinary behavior. Colder supply water stretches the pause.
Also shown as Hd
Hd, also written HO, stands for Heat Delay or Heater On. The dishwasher pauses to bring its water up to temperature before washing, which is ordinary behavior. Colder supply water stretches the pause.
The pause is the dishwasher heating the water, and the cycle carries on afterward.
Hd stays on much longer than heating the water would take.
Your checklist, kept on this device

The pause is the dishwasher heating the water, and the cycle carries on afterward.

The article says each degree of temperature rise takes about 1 to 2 minutes.

Run the kitchen tap hot before starting, a general tip of ours that shortens the wait.

If the code seems stuck for much longer than the water should need, the heating needs a look.
Send us the model and the checks you have done, and open your request here.
Book a visitA simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
The cycle waits while the heater brings the water to the temperature the wash needs.
Read the supporting manualColder water takes longer. Electrolux puts it at roughly one to two minutes for each degree the water has to rise.
Read the supporting manualThe article gives no method. Starting with hotter water from the tap is common sense and ours, not Electrolux's.
Read the supporting manualManufacturer document
Electrolux / Owner Center knowledge base (owner.electrolux.com)
Owner Center article, fetched 10.11.2026 (no edition date printed) / Article text
Electrolux Owner Center article 1830362 (Dishwashers).
No. The article describes it as normal heating time.
It may simply be waiting on Hd. Give the heater time before assuming trouble.
No. 01-24 is a delayed start with a countdown. Hd is a heating pause.
A pause far longer than the incoming water temperature could explain.
Codes, symptoms, parts and service
A dishwasher displaying 01-24 has a delayed start programmed and is counting down to 0 before the cycle begins. It has not failed. Press Cancel to drop the delay; a second press scraps the cycle and drains, and a third switches the washer off.
Flashing lights and display codes on an Electrolux dishwasher are not always a breakdown. A delay countdown (01-24) and a heat delay (Hd or HO) are normal waiting states, while i20 and i40 point to draining and a clogged filter or sump.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.