What it means
E51 is a motor relay failure on Electrolux's dryer chart: the relay that switches the motor is stuck open or closed, or its wiring is defective. Unplug the dryer and book a technician; the chart's tests need the cabinet open.
Electrolux dryer E51 / Motor
E51 is a motor relay failure on Electrolux's dryer chart: the relay that switches the motor is stuck open or closed, or its wiring is defective. Unplug the dryer and book a technician; the chart's tests need the cabinet open.
Also shown as E51
E51 is a motor relay failure on Electrolux's dryer chart: the relay that switches the motor is stuck open or closed, or its wiring is defective. Unplug the dryer and book a technician; the chart's tests need the cabinet open.
If the motor runs on its own or will not start, cut the power at the plug or the breaker.
The drum runs continuously with the cycle stopped, or will not start and E51 returns.
Your checklist, kept on this device

If the motor runs on its own or will not start, cut the power at the plug or the breaker.

The chart separates two cases: a motor that runs continuously with power applied, and a motor that does not start when Start is pressed.

Retrying a dryer whose motor runs when it should not is risky. Stop after one attempt.

Tap any button other than Cancel to wake the dryer, then keep Cancel and Start/Pause pressed together for six seconds.

The chart checks for a short across the motor relay, then an open circuit in its wiring, then replaces the electronic control board.
Send us the model and the checks you have done, and open your request here.
Book a visit
A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
The motor relay is not behaving: stuck open or closed, or its wiring is defective, according to the chart's possible conditions.
Read the supporting manualIf the motor runs continuously with power applied, the technician looks for a short across relay RL2 or L1 on its output. If the motor will not start, the technician looks for an open circuit between L1 and the relay.
Read the supporting manualA motor that cannot be switched off reliably is a hazard. Unplug it.
Read the supporting manualE52 is a motor stopped or not starting, E53 is a centripetal switch and E54 is motor sensing. E51 is the relay.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
P/N 137265000B (1202); Canadian SKU EIMED6CJIW; original file dated 2009 / sheet p.1 (Error Code Chart)
Row E51 of the dryer chart, page 1. It names relay RL2 and board terminals J3-1 and J3-2.
A switch on the control board that powers the drum motor. The chart names it RL2.
That clears the message only. A relay that is stuck will stick again.
No. The chart replaces the board or fixes wiring, not the motor, for this row.
For E51, the model number and whether the drum ran by itself or refused to start.
Codes, symptoms, parts and service
E52 means the dryer motor stopped or will not start, per Electrolux's dryer chart. The listed conditions are an overheated motor, a load that is too heavy, low supply voltage, or a defective motor or wiring. Take the load out and let it cool.
Most dryer noise has a simple source: coins or buckles in the drum, a loose pedestal, shipping bolts still in place or a dryer that is out of level. Electrolux also lists sounds that are normal, such as the chime at the end of a cycle.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.