E52 means the dryer motor stopped or will not start, per Electrolux's dryer chart. The listed conditions are an overheated motor, a load that is too heavy, low supply voltage, or a defective motor or wiring. Take the load out and let it cool.
E52 means the dryer motor stopped or will not start, per Electrolux's dryer chart. The listed conditions are an overheated motor, a load that is too heavy, low supply voltage, or a defective motor or wiring. Take the load out and let it cool.
E52 means the dryer motor stopped or will not start, per Electrolux's dryer chart. The listed conditions are an overheated motor, a load that is too heavy, low supply voltage, or a defective motor or wiring. Take the load out and let it cool.
What you can safely check
Take the laundry out.
When to call a technician
E52 returns after a cooling pause and a small load.
Your checklist, kept on this device
Safe checks, in order.
0 of 5 checks done
Illustration. Follow your model’s instructions.
Before you begin
Unplug and unload
Take the laundry out. Electrolux's stops-operating article says an overloaded dryer can overheat its motor.
Illustration. Follow your model’s instructions.
Check 2
Turn the drum by hand
With the plug out, the drum should turn freely. The chart's first step is to check that it does.
Illustration. Follow your model’s instructions.
Check 3
Let the motor cool
If the motor's thermal protector has tripped, the chart says it may take up to 30 minutes to reset. Wait before you try again.
Illustration. Follow your model’s instructions.
Check 4
Try a smaller load
The article says an average washer load fills the drum one third to one half. Restart with less.
Illustration. Follow your model’s instructions.
Check 5
Book a visit
If E52 returns on a small load, the chart checks the L1 supply voltage, the motor wiring and the thermal protector.
Still showing E52?
Send us the model and the checks you have done, and open your request here.
The motor is stopped or is not starting. The chart's row reads motor stopped or not starting, and the conditions are overheating, a heavy load, low supply or a defective motor or wiring.