What it means
F96 means the oven door was detected open during a self clean cycle, on Electrolux's modular wall oven control. The sheet says the door switch lost contact. Make sure the door closes fully and nobody pulls on it during the cycle.
Electrolux oven F96 / Door lock
F96 means the oven door was detected open during a self clean cycle, on Electrolux's modular wall oven control. The sheet says the door switch lost contact. Make sure the door closes fully and nobody pulls on it during the cycle.
Also shown as F96
F96 means the oven door was detected open during a self clean cycle, on Electrolux's modular wall oven control. The sheet says the door switch lost contact. Make sure the door closes fully and nobody pulls on it during the cycle.
The sheet wants the door to close well and fully press the door switch plunger when the door is locked.
F96 returns on a clean cycle with the door closing properly.
Your checklist, kept on this device

The sheet wants the door to close well and fully press the door switch plunger when the door is locked.

F96 can result if someone tries to open the oven door during a self clean cycle.

Turn the breaker off, count to 30 and switch it on again before starting another clean.

A door that sags or does not seat can lose the switch.

The sheet tests the wiring between the door switch and the oven relay board, replaces the door switch if it is defective, then replaces the relay board.
Send us the model and the checks you have done, and open your request here.
Book a visit
A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
The door switch lost contact during self clean, so the control saw the door as open while the cycle ran.
Read the supporting manualMake sure the oven door closes well, fully presses the door switch plunger when locked, and no one pulled on it. Then test continuity of the wiring and the switch with an ohmmeter.
Read the supporting manualOnly after the door closes properly. A self clean cycle runs very hot.
Read the supporting manualF95 and F97 concern the lock motor and its switch. F96 concerns the door switch during a clean cycle.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
Models: EI30EW38TS
p/n A00980644 Rev A (2017/05) / PDF p.2
Row F96 of the 2017 modular-control sheet, page 2, modular oven controls.
The control locks the door for safety. Wait until the cycle finishes and the door unlocks.
Not necessarily. The sheet checks closure and the switch first.
The sheet ties F96 to a self clean cycle, when the door is locked. A door that opens during ordinary baking is not the case it describes.
For F96, the model number and what happened to the door during the clean cycle.
Codes, symptoms, parts and service
F95 is a motor door lock mechanism failure on Electrolux's modular wall oven control: the lock motor does not stop running, or the lock switch sends an invalid signal. Reset power; if F95 returns, book a technician.
The written Electrolux articles say little about setting the clock or timer, since its display-settings guide is a video. What they do cover is a display or keypad that acts up: a stuck key (F11), memory and cable errors (F13, F14, F15), Demo mode and a power reset.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.