On this page
- On a new unit, check for Styrofoam and shipping bolts first. 1
- The legs may extend no more than half an inch below the washer bottom. 1
- A loose drain hose knocks against the back; a zip tie fixes it. 1
- Rattling can be coins or clothing fasteners; an empty cycle tells you which. 1
- The sheet's F5 means load unbalanced and is not shown on the display. 2
Which Electrolux washer noises are normal?#
Clicks from the door lock and the water valves, a double click as the lock engages or releases, gurgling while it drains, a high-pitched whine at spin, a low hum from the drain pump and the rush of water filling are all listed by Electrolux as ordinary. 1
The guide pairs each sound with a cause. It is worth reading as a table, because a worried owner often hears a normal sound as a new one:
| Sound | What Electrolux says it is |
|---|---|
| One single beep | A change attempted after the cycle started; flashing lights follow 1 |
| Clicks | Door locking, water valves opening 1 |
| Double clicking | The lock engaging or disengaging 1 |
| Gurgling or bubbling | Draining 1 |
| High-pitched jet engine | The unit spinning 1 |
| Low humming | The drain pump in use 1 |
| Water rushing | Water filling 1 |
Other sounds on the list have a check attached, and those are the rest of this guide: humming that may come from the water valve, knocking, rattling, thumping and vibrating. 1
What should I check on a newly installed washer?#
Check that every piece of shipping material is gone, including any Styrofoam under the unit and the shipping bolts, then that the unit is level on a solid floor. Electrolux says not to place a washer on carpet, loose plywood or any unstable surface. 1
Electrolux's article opens with this exact list, and points you to the installer when the unit is under a month old. 1
- 1
- 2
- 3
- 4
If the washer is stacked#
Electrolux adds three checks for a stacked pair: the stacking kit is properly installed, the feet on the washer and dryer are completely screwed in, and all brackets are screwed tight. 1
If you are not sure the stacking kit was installed correctly, that check is one for a technician.
Why does my washer thump or shake on spin?#
Heavier loads can thump briefly at the start of spin. If it keeps shaking, the load is probably unbalanced or the washer is not level. Turn the power off, wait for the lid to unlock, spread the clothes and, for a small load, add one or two matching pieces. 1
The same article lists the two causes separately, so you can work through them one at a time:
- Unbalanced load. Power off, wait for the lock to release, redistribute the clothes evenly, restart. If it is still off balance, add one or two matching pieces to a small load. 1
- Washer not level. The washer needs to rest firmly on the floor, level both front to back and side to side, with each leg solid. 1
- Shipping bolts. The thumping entry carries a note to double-check that the bolts have been removed. 1
The technician sheet has a line for the first cause. F5 is Load unbalanced; it is not shown on the display, and the next step is to redistribute the load and restart. The page for F5 says the same in more detail. 2
What about rattling, knocking and humming?#
Rattling and clanking can be loose objects such as coins in the drum or belt buckles and other fasteners on the clothes. Run an empty cycle; if the sound stays, it is not the load. Knocking can be the drain hose, and a hum can come from the water valve. 1
- Rattle or clank. Fasten buckles or turn clothes inside out to reduce the sound, and check the drum for coins. 1
- Knock. An unsecured drain hose can hit the back of the unit. Secure it with zip ties. 1
- Hum. The article says this can be caused by the water valve. Make sure the water is turned on and flowing. 1
A hum with the water turned off and a clear drain is not on the list, and the guide does not decode it. That is the kind of sound that deserves a visit.
When does a noise need a technician?#
Book when a grinding, banging or scraping sound continues with an empty drum after the bolts, legs and hoses are right, when the washer walks across the floor on a level floor and a balanced load, or when a hum continues with water on and a clear drain. 1
Next step: \book a visit\, or look over our washer service. The technician agrees the price with you before any work starts. The exact cost is confirmed after the on-site diagnostic. If your unit is under the manufacturer's warranty, the manufacturer handles that repair. We give a warranty on our workmanship.
Sources#
- Laundry Washers Noises Guide (KB 1820062)Electrolux / Owner Center knowledge base (owner.electrolux.com) · Owner Center article, cached 10.11.2026 (no edition date printed) · article text
- Washer Tech Data Sheet, A11200302 (1803)Electrolux (technician sheet; retailer-hosted copy) · A11200302 (1803); 2018, 300/400/500/600 series · p.4 (Washer Error Codes: F5)





