Start from the symptom

Electrolux dishwasher will not start.

A dishwasher that seems idle may be waiting. A delayed start (01-24) holds the cycle until the countdown reaches 0, and a heat delay (Hd or HO) pauses while the water warms. Check these before looking for a failure.

Last reviewed

Hand pressing the top of a closed stainless steel dishwasher door at the handle and latch area in a kitchen with oak cabinets
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Start with safe observations.

Power the appliance down and pull the plug before any owner check. Beware of standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or step beyond your model’s owner guide.

  1. 1

    Check for a delayed start

    If 01-24 or a countdown shows, the delay option is on. Press or hold Cancel to stop it. Pressing again cancels the cycle and starts a drain, and a third press shuts the unit off.

  2. 2

    Allow the heat delay

    Hd or HO means the water is being heated. Colder incoming water takes longer, roughly 1 to 2 minutes per degree of rise.

  3. 3

    Reset the power

    Electrolux's reset options for dishwasher codes include holding Cancel, switching off at the breaker and unplugging for 3 minutes.

  4. 4

    Drain and filter

    If i20 or i40 is shown, the drain hose, the disposer knockout plug or a dirty filter may be behind it. See the lights page.

  5. 5

    Door

    Make sure the door is shut fully before starting. Electrolux's cached dishwasher articles do not cover door latches, so check the manual if it will not catch.

If the display adds a code.

No code is tied directly to this topic.

No further researched dishwasher code is tied to this topic. Match the exact message to your model manual and do not swap in another code from the library.

See the research status

When observation becomes a service request.

Leave internal testing to a technician.

Book a visit if the dishwasher shows nothing, does not respond to Cancel or a power reset, or will not latch. Tell us what the display shows.

Arrange a diagnostic

Sources and model boundaries.

These sources back the Electrolux dishwasher will not start guidance. Use the manual for your own model.

  • Dishwasher Error Code 01-24 - Delayed option has been activated (KB 1830334)
  • Dishwasher Error Code Hd or HO - Heat delay or heater on mode activated (KB 1830362)
  • Dishwasher Error Code i20 - Unit did not drain properly (KB 1830367)

Follow the guide for your exact model. Consult how we research these pages.

Here to help

Good questions.
Clear answers.

Talk to our team
Why does my dishwasher not start right away?

It may have a delay option on (01-24) or be heating water (Hd or HO). Both are waiting states that end by themselves.

How do I cancel a delayed start?

Press or hold Cancel. A second press cancels the cycle and begins a drain, and a third press turns the unit off.

How long does the heat delay last?

It depends on the water temperature. Electrolux says about 1 to 2 minutes for each degree the water must rise.

Does a power reset help?

It can clear a stuck code. Electrolux lists turning the power off at the breaker or unplugging for 3 minutes.

Let’s take care of it.

Premium appliances deserve
careful service.