Inside the appliance
Dishwasher drain hose. In plain English.
The drain hose carries wastewater away from the tub. When Electrolux shows i20, the unit did not drain properly, and the hose is the second item on its list: free of blockage and pinching and at a height of 32 inches or more.

Where it fits.
Dishwasher drain hose in the appliance
It leaves the dishwasher at the back and runs to the sink drain or disposer. The article calls it the drain hose and gives no more detail.
The image shows the type of component only. It does not select a replacement that fits your model.
What is different once this system needs attention.
Dishwasher drain hose concerns may show up with a drop in performance or a code that keeps returning. Testing comes first before anyone decides the component has failed.

Electrolux dishwasher lights flashing or showing a code
Flashing lights and display codes on an Electrolux dishwasher are not always a breakdown. A delay countdown (01-24) and a heat delay (Hd or HO) are normal waiting states, while i20 and i40 point to draining and a clogged filter or sump.

Electrolux dishwasher will not start
A dishwasher that seems idle may be waiting. A delayed start (01-24) holds the cycle until the countdown reaches 0, and a heat delay (Hd or HO) pauses while the water warms. Check these before looking for a failure.
Owner care, within the model instructions.
Power the appliance down and pull the plug before any owner check. Beware of standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or step beyond your model’s owner guide.
- 1
Check for a blockage
KB 1830367 asks you to confirm the hose is not blocked or obstructed.
- 2
Check for a pinch
The same list asks whether the hose is pinched or restricted. Describe any kink you can see when you book.
- 3
Check the height
The article gives a minimum hose height of 32 inches above the floor.
- 4
Reset
Hold Cancel, flip the breaker off, or leave the dishwasher unplugged for 3 minutes.
Cleaning or replacement?
Leave internal testing to a technician.
Book a technician if i20 returns after the hose, the knockout plug and the glass trap are clear.
Book a technician if the hose has to be moved behind cabinets or raised to reach 32 inches.
Arrange a diagnosticSources and model boundaries.
These sources back the Dishwasher drain hose guidance. Use the manual for your own model.
- Dishwasher Error Code i20 - Unit did not drain properly (KB 1830367)
Follow the guide for your exact model. Consult how we research these pages.
What does i20 mean on an Electrolux dishwasher?
The dishwasher is not draining properly. Electrolux lists the knockout plug, the drain hose and the glass trap as the places to look.
How high must the drain hose run?
The article sets a minimum of 32 inches above the floor.
How do I reset i20?
Hold Cancel, flip the breaker off, or leave the dishwasher unplugged for 3 minutes.
Is the drain hose the only cause of i20?
No. A knockout plug left in the disposer inlet, or a dirty glass trap, can cause it as well.
Codes, symptoms, parts and service
Link the message to what to do next.
Electrolux dishwasher lights flashing or showing a code
Flashing lights and display codes on an Electrolux dishwasher are not always a breakdown. A delay countdown (01-24) and a heat delay (Hd or HO) are normal waiting states, while i20 and i40 point to draining and a clogged filter or sump.
Dishwasher repair
Book a diagnostic for your model at the appliance.
Find your metro
Office details and the access information to pass on.

