Start from the symptom

Electrolux refrigerator doors misaligned or not closing.

Doors that sit unevenly or will not close can be adjusted. Electrolux describes how to level side-by-side and French door models, and notes that a poor seal brings frost and warm-temperature alerts.

Last reviewed

A stainless french-door refrigerator whose left door sits slightly higher than the right, with a yellow level resting on the cabinet above.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Start with safe observations.

Power the appliance down and pull the plug before any owner check. Beware of standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or step beyond your model’s owner guide.

  1. 1

    Side by side

    Remove the set screw that locks the door height. If a door sits low, raise it by turning its adjustment screw counterclockwise with a 7/16 inch wrench. Afterward, check that the door stop contacts the lower hinge and the top of the door never touches the upper hinge.

  2. 2

    Lock the height back in

    Reinstall the set screw, then refit the toe grille.

  3. 3

    French door

    Open the freezer drawer to reach the hinges of the fresh food doors. Use the 6 mm Allen wrench supplied with the unit in the lower hinge shaft. Counterclockwise lowers the door and clockwise raises it, seen from below.

  4. 4

    Watch the alarm

    If a door has stayed open for 5 minutes, a Door Ajar alarm sounds. Close it and press Set.

  5. 5

    Check the gasket

    A warped door or gasket prevents a good seal, which can lead to frost and a High Temp alarm.

  6. 6

    Items in the way

    Make sure nothing, such as a shelf item, prevents the door from closing.

If the display adds a code.

Keep the exact message.

We have not researched the code meanings for this appliance. Turn to its model manual and attach a photo of the display to your request.

See the research status

When observation becomes a service request.

Leave internal testing to a technician.

Book a visit if the doors will not line up or close after adjustment, or if the gasket is torn or warped. Tell us whether yours is a side-by-side or French door model.

Arrange a diagnostic

Sources and model boundaries.

These sources back the Electrolux refrigerator doors misaligned or not closing guidance. Use the manual for your own model.

  • Refrigerators - How to align doors (KB 1898514)
  • What do the alarms or error messages mean on my French-Door refrigerator? (KB 1853035)
  • Refrigerators / Freezer - Frost Build Up (KB 1918348)

Follow the guide for your exact model. Consult how we research these pages.

Here to help

Good questions.
Clear answers.

Talk to our team
How do I align my side-by-side refrigerator doors?

Remove the set screw, turn the adjustment screw counterclockwise with a 7/16 inch wrench to raise the lower door, check the stop and hinge, then replace the set screw.

What tool do I need for French doors?

The 6 mm Allen wrench that comes with the unit. Counterclockwise lowers the door and clockwise raises it, looking from below.

What does Door Ajar mean?

This alarm sounds when a door stays open for 5 minutes or more. Close it and press the Set key to reset the alarm.

Can crooked doors cause frost?

They can. A door that does not seal lets warm air in, and Electrolux lists a warped door or gasket as a cause of frost.

Let’s take care of it.

Premium appliances deserve
careful service.