What it means
i40 points to a clogged filter or sump, where food soil has piled up. Clean out the glass trap, then run the dishwasher again. A code that returns after a clean means a technician should check the drain beyond the filter.
Electrolux dishwasher i40 / Drain
i40 points to a clogged filter or sump, where food soil has piled up. Clean out the glass trap, then run the dishwasher again. A code that returns after a clean means a technician should check the drain beyond the filter.
Also shown as i40
i40 points to a clogged filter or sump, where food soil has piled up. Clean out the glass trap, then run the dishwasher again. A code that returns after a clean means a technician should check the drain beyond the filter.
Breaker off or plug out, then lift the filter assembly clear.
i40 returns after the glass trap and sump are clean.
Your checklist, kept on this device

Breaker off or plug out, then lift the filter assembly clear.

Rinse away the soil under the tap; a soft brush helps with film.

Check the sump area under the filter for built-up soil.

Refit the parts correctly and run the unit again to see if i40 stays away.
Send us the model and the checks you have done, and open your request here.
Book a visitA simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.

Component reference
The glass trap and filter collect food soil before the drain.
Read the definitionA clogged filter or sump: the article describes food soils built up in the sump.
Read the supporting manualEmpty and rinse the glass trap, then run the unit again. A separate Glass Trap and Filter Guide covers the removal steps.
Read the supporting manualWhen cleaning the trap and sump does not clear i40, or when the unit still will not drain afterwards.
Read the supporting manualManufacturer document
Electrolux / Owner Center knowledge base (owner.electrolux.com)
Owner Center article, fetched 10.11.2026 (no edition date printed) / Article text
Electrolux Owner Center article 1831281 (Dishwashers).
Neighbors. i20 reports poor draining along the whole path; i40 narrows it to the filter or sump.
No interval is published. Clean it when you spot soil or notice sluggish draining.
Clean first, since a blocked filter leaves dirty water in the tub.
Take care when emptying a glass trap, and wear gloves if you have had a breakage.
Codes, symptoms, parts and service
A dishwasher showing i20 failed to drain properly. Work through the drain path: disposer knockout plug removed, hose clear and unpinched and at least 32 inches above the floor, glass trap free of food. Then clear the code by holding Cancel, cycling the breaker, or unplugging for three minutes.
Flashing lights and display codes on an Electrolux dishwasher are not always a breakdown. A delay countdown (01-24) and a heat delay (Hd or HO) are normal waiting states, while i20 and i40 point to draining and a clogged filter or sump.
The glass trap and filter collect food soil before the drain. Electrolux ties both i20 and i40 to them: i40 is printed as a clogged filter or sump, caused by food residue that has collected, and i20 lists the glass trap among the things to clear.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.