What it means
F50 is an A/D out of range error on Electrolux's modular wall oven control: the oven relay board cannot read the status of the switches, such as the door switch and the lock motor switch. Reset power; if F50 returns, book a technician.
Electrolux oven F50 / Door lock
F50 is an A/D out of range error on Electrolux's modular wall oven control: the oven relay board cannot read the status of the switches, such as the door switch and the lock motor switch. Reset power; if F50 returns, book a technician.
Also shown as F50
F50 is an A/D out of range error on Electrolux's modular wall oven control: the oven relay board cannot read the status of the switches, such as the door switch and the lock motor switch. Reset power; if F50 returns, book a technician.
Leave the breaker off for 30 seconds before turning it on again.
F50 returns after a reset and a firm door closure.
Your checklist, kept on this device

Leave the breaker off for 30 seconds before turning it on again.

The relay board reads the door switch, so a door that is not closing properly can contribute. Open it and shut it again firmly.

Did the door lock motor run before F50? Tell us what you heard.

The switches, lock motor and probes are joined by splices and junctions behind the oven.

The sheet checks the connections between the door switch, the lock motor and the temperature probes, including every splice and junction, then replaces the oven relay board.
Send us the model and the checks you have done, and open your request here.
Book a visit
A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
The oven relay board's analog readings for the door and lock switches are out of range. The sheet explains it as the board being unable to read the status of the switches (door, MDL).
Read the supporting manualWhether the connections between the door switch, the motor door lock and the temperature probes are properly made, including all splices and junctions.
Read the supporting manualF90 to F97 describe the lock motor and its switches doing the wrong thing. F50 says the board cannot read those switches at all.
Read the supporting manualThe oven may not start, since the board cannot confirm the door.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
Models: EI30EW38TS
p/n A00980644 Rev A (2017/05) / PDF p.2
Row F50 of the 2017 modular-control sheet, page 2, modular oven controls.
It may involve the door switch, but the sheet looks at the whole circuit between the switches and the relay board.
The sheet's F50 row lists no reset step. A reset only rules out a glitch.
The sheet says the connections of the door switch, the lock and the probes share the same junctions and splices.
For F50, the model number and whether the door and lock behaved normally before F50.
Codes, symptoms, parts and service
F90 on an Electrolux oven is a door lock motor mechanism failure. The ES630 sheet says door motor mechanism failure, and the modular sheet says the control does not see the lock motor running. Press UNLOCK if the door is locked, then reset the power.
The written Electrolux articles say little about setting the clock or timer, since its display-settings guide is a video. What they do cover is a display or keypad that acts up: a stuck key (F11), memory and cable errors (F13, F14, F15), Demo mode and a power reset.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.