F90 on an Electrolux oven is a door lock motor mechanism failure. The ES630 sheet says door motor mechanism failure, and the modular sheet says the control does not see the lock motor running. Press UNLOCK if the door is locked, then reset the power.
F90 on an Electrolux oven is a door lock motor mechanism failure. The ES630 sheet says door motor mechanism failure, and the modular sheet says the control does not see the lock motor running. Press UNLOCK if the door is locked, then reset the power.
Service Data Sheet, p/n 807436903, "Appliance with ES630 Electronic Oven Control" (EW30EW65PS)
What Electrolux oven F90 means.
What it means
F90 on an Electrolux oven is a door lock motor mechanism failure. The ES630 sheet says door motor mechanism failure, and the modular sheet says the control does not see the lock motor running. Press UNLOCK if the door is locked, then reset the power.
What you can safely check
The Owner Center guide says to press UNLOCK and follow the screen.
When to call a technician
The door stays locked or F90 returns after a reset.
Your checklist, kept on this device
Safe checks, in order.
0 of 5 checks done
Illustration. Follow your model’s instructions.
Before you begin
Press UNLOCK if the door is locked
The Owner Center guide says to press UNLOCK and follow the screen. It will show a code to unlock the door and controls. [6]
Illustration. Follow your model’s instructions.
Check 2
Do not force the door
Forcing a locked door can break the latch. Wait and follow the screen.
Illustration. Follow your model’s instructions.
Check 3
Reset the power
Remove power for 30 seconds, then switch it on again by unplugging or flipping the breaker, then try a lock or clean cycle again. [6]
Illustration. Follow your model’s instructions.
Check 4
Press any key on an ES630
The ES630 sheet says to press any key to clear the error before power-cycling.
Illustration. Follow your model’s instructions.
Check 5
Book a visit
The sheets test the lock motor, the lock switch and the door switch wiring and replace the motor lock assembly, and the relay or display board if needed.
Still showing F90?
Send us the model and the checks you have done, and open your request here.
The oven's door lock motor did not do what the control expected. The ES630 sheet says door motor mechanism failure; the modular sheet says the control does not see the lock motor running.
Whether the lock motor runs when it should, 120VAC at the motor, and the lock switch with an ohmmeter. A motor that gets voltage but does not turn is replaced; a motor that never gets voltage points to the board.