What it means
E58 is high current on the motor phase in Electrolux's 2018 washer sheet, one of the codes the display does not show. Unplug the washer, take weight out of the drum, and book a technician to test the motor.
Electrolux washer E58 / Motor
E58 is high current on the motor phase in Electrolux's 2018 washer sheet, one of the codes the display does not show. Unplug the washer, take weight out of the drum, and book a technician to test the motor.
Also shown as E58
E58 is high current on the motor phase in Electrolux's 2018 washer sheet, one of the codes the display does not show. Unplug the washer, take weight out of the drum, and book a technician to test the motor.
Unplug the washer before looking at the door or drum.
E58 returns on a light load, or the breaker trips when the washer runs.
Your checklist, kept on this device

Unplug the washer before looking at the door or drum. The sheet is clear that the unit should be disconnected before servicing.

Remove laundry until the drum holds a modest load. Test 8's first question is whether the unit was overloaded.

With the power off, turn the drum a little. It should move without grinding.

During fill, wash or spin? The stage tells a technician which motor load was in play.

Winding resistance, pulley checks and the motor control board are all part of the sheet's route.
Send us the model and the checks you have done, and open your request here.
Book a visit
A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
Too much current flowed in one phase of the motor. The sheet words it high current on motor phase and does not show it to the owner.
Read the supporting manualFollow test 8: confirm no overload, spin the motor pulley and tub pulley for stiffness, measure the three winding pairs and compare with 3 to 6 ohms.
Read the supporting manualThe test removes the belt to isolate the motor, so a stiff tub or seized bearing is on the list too.
Read the supporting manualIf the washer smells hot or trips the breaker, stop using it.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
A11200302 (1803); 2018, 300/400/500/600 series (EFLS527UTT and EFLS627UTT copies are byte-identical) / p.1 (Washer Error Codes)
Row 58 of the 2018 washer sheet. Test 8 is shared with E57 and E5A.
The motor has three windings. The sheet measures between each pair of them.
That is the range the sheet gives for healthy windings. Readings outside it point at the motor.
With a light load, once. If E58 comes back on the second try, stop and leave the washer unplugged until a technician has looked.
Related, not identical: E57 is the inverter, E58 the phase.
Codes, symptoms, parts and service
E57 is high current on the inverter, the motor control, in Electrolux's 2018 washer sheet. The display does not show E57. Unplug the washer, reduce an overloaded drum if you can, and book a technician for the motor tests.
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.