What it means
E85 is a recirculation pump triac alarm that stops the cycle, on Electrolux's 2018 washer sheet, for select models. The display does not show E85. Book a technician; the sheet checks the pump wiring, the pump and then the board.
Electrolux washer E85 / Pump
E85 is a recirculation pump triac alarm that stops the cycle, on Electrolux's 2018 washer sheet, for select models. The display does not show E85. Book a technician; the sheet checks the pump wiring, the pump and then the board.
Also shown as E85
E85 is a recirculation pump triac alarm that stops the cycle, on Electrolux's 2018 washer sheet, for select models. The display does not show E85. Book a technician; the sheet checks the pump wiring, the pump and then the board.
Note whether the alarm came during a wash with the recirculation system active.
E85 stops a second cycle.
Your checklist, kept on this device

Note whether the alarm came during a wash with the recirculation system active. It helps pinpoint the circuit.

Cut the power before you look at the tub or drain any water. The pump circuit carries line voltage.

A pump circuit that alarms can stress its switch. One restart is enough to see if it repeats.

Power up, pause ten seconds, then hold the Temp and Select buttons together for a count of three.

Test 21 checks the wiring to the pump, the pump itself and then the main board.
Send us the model and the checks you have done, and open your request here.
Book a visit
A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
The switch that powers the recirculation pump raised an alarm, and the control stopped the cycle. The sheet word it recirculation pump triac alarm which stops the cycle.
Read the supporting manualThe technician checks the wiring to the recirculation pump. If wiring is bad it is corrected; if good, the pump is replaced, and the main board is replaced if the code stays.
Read the supporting manualE84 is the sensing of the same switch and goes straight to the board. E85 has a pump-and-wiring test first.
Read the supporting manualOnly if the washer completes cycles normally. A repeat alarm means stop.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
A11200302 (1803); 2018, 300/400/500/600 series (EFLS527UTT and EFLS627UTT copies are byte-identical) / p.2 (Washer Error Codes)
Row 85 of the washer sheet: select models. Test 21 covers wiring, pump and board.
No. E85 is an electrical alarm on the switch that powers the recirculation pump, not a water leak.
The sheet does not name a blockage. It checks the wiring and pump electrically.
No. For E85 the sheet's display column says no, so the stored-error recall is the way to see it.
Select models that have a recirculation pump. Your model label tells you whether your washer is one of them.
Codes, symptoms, parts and service
E84 is a recirculation pump triac sensing failure that stops the cycle, on Electrolux's 2018 washer sheet (select models). The display does not show E84. The sheet's next step is to replace the main board, so book a technician.
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.