What it means
LOC on an Electrolux front-load washer is not a failure. It means the control lock is on, which blocks cycles. Scroll to the control lock option and press Select to turn it off. Washer cycles will not run while it is on.
Electrolux washer LOC / Settings
LOC on an Electrolux front-load washer is not a failure. It means the control lock is on, which blocks cycles. Scroll to the control lock option and press Select to turn it off. Washer cycles will not run while it is on.
Also shown as LOC
LOC on an Electrolux front-load washer is not a failure. It means the control lock is on, which blocks cycles. Scroll to the control lock option and press Select to turn it off. Washer cycles will not run while it is on.
Scroll through the options until you reach the control lock symbol.
The lock icon will not clear, or the panel ignores Select.
Your checklist, kept on this device

Scroll through the options until you reach the control lock symbol.

Pressing Select while the lock option is highlighted turns the lock off. The control lock icon on the display goes out.

Choose a cycle and press Start. If the washer now runs, LOC was the whole story.

The lock exists to stop accidental operation by children, so someone may have turned it on on purpose.
If the lock icon will not clear, or the buttons do nothing, tell us the model.
Send us the model and the checks you have done, and open your request here.
Book a visit

A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
The control lock is active. Electrolux explains that it locks the controls between cycles to reduce accidental operation by children, and cycles will not run while it is on.
Read the supporting manualScroll to the control lock option again and press Select. The icon leaves the display.
Read the supporting manualNo. LOC is a feature, not a failure. A repair only comes into it when the lock will not release.
Read the supporting manualElectrolux describes it as locking the controls between cycles. Check your Use and Care guide for how your model behaves mid-cycle.
Read the supporting manualManufacturer document
Electrolux / Owner Center knowledge base (owner.electrolux.com)
Owner Center article, cached 10.11.2026 (no edition date printed) / article text
Owner Center article 1829278 for front-load washers. A feature, not a failure.
Someone likely turned the lock on, perhaps by pressing the option without noticing. The article says nothing about it turning itself on.
No. LOC concerns the control panel. A locked door during a cycle is a separate door-lock feature.
No. Electrolux says washer cycles will not run when control lock is activated.
Unplug the washer for a minute and try again. If the panel still ignores you, book a visit.
Codes, symptoms, parts and service
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.