Inside the appliance
Washer pressure sensor. In plain English.
The pressure sensor tells the washer how high the water stands in the tub. Electrolux’s washer sheet ties it to E13, E31, E32 and E35. E35 means the sensor reports an overfill; E31 and E32 point at the sensor’s own reading or calibration.

Where it fits.
Washer pressure sensor in the appliance
The sheet does not place the sensor. The sheet speaks of its wiring to the main control board and of an air system around it, and it gives no position, so a technician locates it by model.
The image shows the type of component only. It does not select a replacement that fits your model.
What is different once this system needs attention.
Washer pressure sensor concerns may show up with a drop in performance or a code that keeps returning. Testing comes first before anyone decides the component has failed.
Owner care, within the model instructions.
Power the appliance down and pull the plug before any owner check. Beware of standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or step beyond your model’s owner guide.
- 1
Note when it happened
KB 1820074 calls E35 a known installation issue. If the washer was installed or moved recently, ask the installer to confirm the setup.
- 2
Clear the display
The same article says pressing Cancel removes E35, and Start resumes the cycle. If it persists, disconnect the power cord, reconnect it and restart.
- 3
Check the water
If water runs in continuously, shut the faucets. The sheet’s overfill test asks whether water keeps entering with the power removed, which points at the inlet valve.
- 4
Leave air-line checks to us
Test 2 on the sheet looks for an air leak in the sensor system. That is a technician’s check, along with the wiring to the main board.
Cleaning or replacement?
Leave internal testing to a technician.
Book a technician if water keeps filling, or if E13, E31, E32 or E35 returns after a power reset.
Arrange a diagnosticSources and model boundaries.
These sources back the Washer pressure sensor guidance. Use the manual for your own model.
- Washer Tech Data Sheet, A11200302 (1803)
- Laundry front loading washer displaying Error Code E35 pressure sensor indicates water overfill. (KB 1820074)
Follow the guide for your exact model. Consult how we research these pages.
What does E35 mean on an Electrolux washer?
It means the pressure sensor indicates water overfill. KB 1820074 describes the symptom as water running continuously.
What do E31 and E32 mean?
The sheet prints E31 as an electronic pressure switch error and E32 as a pressure sensor calibration problem. Both send the technician to the wiring and then the sensor.
Will the code show on the display?
The sheet marks E13, E31, E32 and E35 as not shown to the user; they sit in memory. Electrolux’s E35 article still treats it as a visible code, so both are quoted here.
How do I see the last code the washer stored?
Press Power, wait at least 10 seconds, then hold Temp and Select together for 3 seconds. Touch any button, or press Power, to leave.
Codes, symptoms, parts and service
Link the message to what to do next.
E13
E13 on an Electrolux front-load washer means water is leaking in the tub or the pressure-sensor line. The sheet does not show it on the display. Shut the taps, unplug the washer if water is escaping, and book a technician.
Electrolux washer not spinning
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
Washer repair
Book a diagnostic for your model at the appliance.
Find your metro
Office details and the access information to pass on.


