Inside the appliance

Dryer heater relay. In plain English.

A heater relay is the switch that sends power to the dryer’s heating element. Electrolux’s dryer sheet ties E61 to it: the relay stuck open or closed, or the wiring around it defective. A technician tests it with the cycle stopped.

Last reviewed

Control board with three black relay switches in a row and a wiring harness plug, on a wood workbench.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Where it fits.

Dryer heater relay in the appliance

The sheet lists three heater relays, labeled RL5, RL6 and RL7, and its last step is to replace the electronic control board. That places them on the board, inside the cabinet, out of reach without taking panels off.

The image shows the type of component only. It does not select a replacement that fits your model.

What is different once this system needs attention.

Dryer heater relay concerns may show up with a drop in performance or a code that keeps returning. Testing comes first before anyone decides the component has failed.

Owner care, within the model instructions.

Power the appliance down and pull the plug before any owner check. Beware of standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or step beyond your model’s owner guide.

  1. 1

    Read the last code

    Wake the dryer with any button except Cancel, then hold Cancel and Start/Pause together for 6 seconds. The display shows an E and two digits. E00 means no error has been recorded.

  2. 2

    Rule out the house supply

    KB 1853007 says an electric dryer uses two house circuits. If one has tripped or blown, the drum can turn while the heater stays off. Reset the breaker, or replace the house fuse.

  3. 3

    Check the cycle

    The same article warns that the Air Fluff cycle, or a no-heat temperature choice, only tumbles. Select low or medium heat and run a short cycle.

  4. 4

    Leave the board alone

    The sheet is written for qualified technicians and starts with a warning to disconnect power. The relays sit on the control board, so this is not an owner repair.

Cleaning or replacement?

Leave internal testing to a technician.

Book a technician if E61 comes back after a breaker and cycle check, or if the drum runs but the dryer never warms.

Arrange a diagnostic

Sources and model boundaries.

These sources back the Dryer heater relay guidance. Use the manual for your own model.

  • Dryer Tech Data Sheet, P/N 137265000B (1202)
  • My dryer is running, but does not seem to be heating. What should I do? (KB 1853007)

Follow the guide for your exact model. Consult how we research these pages.

Here to help

Good questions.
Clear answers.

Talk to our team
What does E61 mean on an Electrolux dryer?

The sheet prints it as Heater Relay failure, with two possible causes: a relay stuck open or closed, or defective wiring. It does not say which of the two you have.

Is E61 the same as a burnt-out heating element?

No. The sheet gives open heater circuits as E64 and a heater shorted to the cabinet as E63. E61 is about the switch that feeds the heater, not the coil itself.

What does the technician do about E61?

The sheet’s steps are to look for a short across the heater relays with the cycle stopped, then for an open circuit to them. If the wiring is sound, the board is replaced and the dryer retested.

My dryer runs but does not heat. Is that E61?

Not necessarily. The Electrolux heating article lists a tripped breaker, a no-heat cycle, wrong outlet voltage and, on gas models, the gas supply. A code on the display is what points at the relay.

Let’s take care of it.

Premium appliances deserve
careful service.