Inside the appliance
Dryer heating element (heater coils). In plain English.
The heating element is the set of heater coils that warm the air in an Electrolux dryer. Electrolux's dryer chart names the element or its wiring for E63 (heater to earth ground) and E64 (heater open circuit). If the drum turns but the air stays cold, check the cycle and both house breakers first.

Where it fits.
Dryer heating element (heater coils) in the appliance
Inside the cabinet behind the drum; the chart does not locate it.
The image shows the type of component only. It does not select a replacement that fits your model.
What is different once this system needs attention.
Dryer heating element (heater coils) concerns may show up with a drop in performance or a code that keeps returning. Testing comes first before anyone decides the component has failed.
Owner care, within the model instructions.
Power the appliance down and pull the plug before any owner check. Beware of standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or step beyond your model’s owner guide.
- 1
Feel the exhaust air
If the drum turns but the air is cold, that fits an open heater circuit.
- 2
Check the cycle
Air Fluff or a no-heat temperature tumbles without warmth. Pick a heated cycle.
- 3
Reset the two breakers
An electric dryer runs on two house circuits or fuses. If one is tripped, the heater will not run.
- 4
Stop on E63
E63 means the element or wiring is shorted to the cabinet. Unplug the dryer and do not run it again until it is checked.
- 5
Leave the back panel on
The heater coils and terminals carry line voltage.
Cleaning or replacement?
Leave internal testing to a technician.
E63 or E64 appears.
The dryer tumbles with no heat after the cycle and breaker checks.
The breaker trips when the dryer heats.
Arrange a diagnosticSources and model boundaries.
These sources back the Dryer heating element (heater coils) guidance. Use the manual for your own model.
- Dryer Tech Data Sheet, P/N 137265000B (1202)
- My dryer is running, but does not seem to be heating. What should I do? (KB 1853007)
Follow the guide for your exact model. Consult how we research these pages.
What does E64 mean on an Electrolux dryer?
It is an open circuit in the heater. The chart names the heating element or wiring and checks the coils and connections.
What does E63 mean?
The heater is shorted to earth ground: the heating element or its wiring touches the cabinet. Unplug the dryer and book a technician.
Why does my dryer tumble with no heat?
Check the cycle first, then both house breakers. An open heater circuit (E64) is the chart's other cause.
Is the heater the same as the heater relay?
No. The relay switches the heater (E61). E63 and E64 name the element and its wiring.
Can I test the coils myself?
No. The coils are line-voltage parts behind the cabinet. Book a technician for resistance tests and replacement.
Codes, symptoms, parts and service
Link the message to what to do next.
E63
E63 is a heater to earth ground failure on Electrolux's dryer chart: the heating element or its wiring is shorted to the cabinet. Unplug the dryer and do not run it again until a technician has checked the heater.
Electrolux dryer noisy, rattling or shaking
Most dryer noise has a simple source: coins or buckles in the drum, a loose pedestal, shipping bolts still in place or a dryer that is out of level. Electrolux also lists sounds that are normal, such as the chime at the end of a cycle.
Dryer repair
Book a diagnostic for your model at the appliance.
Find your metro
Office details and the access information to pass on.


