What it means
E67 is a heaters sensing failure on Electrolux's dryer chart. The chart lists one condition, a defective electronic control board, and one solution: replace it and retest. Book a technician.
Electrolux dryer E67 / Heating
E67 is a heaters sensing failure on Electrolux's dryer chart. The chart lists one condition, a defective electronic control board, and one solution: replace it and retest. Book a technician.
Also shown as E67
E67 is a heaters sensing failure on Electrolux's dryer chart. The chart lists one condition, a defective electronic control board, and one solution: replace it and retest. Book a technician.
Unplug for a minute and run a short timed cycle.
E67 returns, or heat behaves oddly.
Your checklist, kept on this device

Unplug for a minute and run a short timed cycle. A one-off may not return.

Is the exhaust air warm? Tell us whether heating works despite the code.

Two breakers feed an electric dryer. A tripped one gives no heat, which E67 is not.

The sensing circuit is on the control board behind the console.

The chart replaces the electronic control board and retests.
Send us the model and the checks you have done, and open your request here.
Book a visit

A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.

Component reference
A heater relay is the switch that sends power to the dryer’s heating element.
Read the definition
Component reference
The dryer electronic control board is the main board of an Electrolux front-load dryer, and the interface board is the console board that talks to it.
Read the definitionThe control cannot confirm what the heaters are doing. The chart reads heaters sensing failure and names the electronic control board as defective.
Read the supporting manualE61 and E64 point to relays and heater wiring. E67 is the sensing circuit, which lives on the board, so the chart goes straight to the board.
Read the supporting manualIt may. The code tells you the control's readback is wrong, not necessarily that heat is gone.
Read the supporting manualIf heat is normal and cycles end properly, schedule the visit at your convenience. If the dryer overheats, stop.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
P/N 137265000B (1202); Canadian SKU EIMED6CJIW; original file dated 2009 / sheet p.1 (Error Code Chart)
Row E67 of the dryer chart, page 1.
No. E61 is a heater relay stuck or its wiring defective. E67 is the sensing of the heaters.
The chart does not list the element for E67. E63 and E64 cover the element.
It may after a restart, but a defective board repeats the code.
For E67, the model number and whether the dryer heated normally, so we can tell a sensing problem apart from a real loss of heat.
Codes, symptoms, parts and service
E61 is a heater relay failure on Electrolux's dryer chart: a heater relay is stuck open or closed, or the wiring is defective. If the dryer runs without heat, or heats when it should not, unplug it and book a technician.
Most dryer noise has a simple source: coins or buckles in the drum, a loose pedestal, shipping bolts still in place or a dryer that is out of level. Electrolux also lists sounds that are normal, such as the chime at the end of a cycle.
A heater relay is the switch that sends power to the dryer’s heating element. Electrolux’s dryer sheet ties E61 to it: the relay stuck open or closed, or the wiring around it defective. A technician tests it with the cycle stopped.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.