Inside the appliance

Dryer high-limit thermostat. In plain English.

The high-limit thermostat is a second temperature guard inside the dryer. Code E65 means the control has counted too many of its trips. Electrolux’s sheet blames a high vent restriction first, then the thermostat itself, then the inlet limiter on electric models.

Last reviewed

Round metal disc thermostat with two spade terminals next to a clump of gray lint and a foil duct.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work

Where it fits.

Dryer high-limit thermostat in the appliance

The sheet names the part without placing it. It sits in the heated air path with the thermal limiters, and a technician reaches it by model, after unplugging the dryer.

The image shows the type of component only. It does not select a replacement that fits your model.

What is different once this system needs attention.

Dryer high-limit thermostat concerns may show up with a drop in performance or a code that keeps returning. Testing comes first before anyone decides the component has failed.

Owner care, within the model instructions.

Power the appliance down and pull the plug before any owner check. Beware of standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or step beyond your model’s owner guide.

  1. 1

    Look at the lint screen

    KB 1847456 asks for the lint screen to be cleaned before or after each load. KB 1847456 adds that a screen can be washed in warm soapy water to remove residue, as long as it is dried fully before it goes back.

  2. 2

    Inspect the exhaust path

    KB 1853008 has you check the duct for clogs, keep any screen off the hood opening, fit a hood whose damper swings out, and leave 12 inches below the hood.

  3. 3

    Mind the gas rule

    The same article warns of carbon monoxide poisoning if a gas dryer is ever run without an exhaust duct to the outdoors.

  4. 4

    Count the repeats

    Note whether E65 shows after every long cycle or only on heavy loads. A technician reads that pattern against the sheet’s steps.

Cleaning or replacement?

Leave internal testing to a technician.

Book a technician if E65 returns after the lint screen and vent are clear. The thermostat and the limiter need meter checks.

Arrange a diagnostic

Sources and model boundaries.

These sources back the Dryer high-limit thermostat guidance. Use the manual for your own model.

  • Dryer Tech Data Sheet, P/N 137265000B (1202)
  • Dryer - Not Drying and Extended Drying Time (KB 1853008)
  • Dryers - How often do I need to clean my dryer or the lint screen/filter to optimize my drying performance? (KB 1847456)

Follow the guide for your exact model. Consult how we research these pages.

Here to help

Good questions.
Clear answers.

Talk to our team
What does E65 mean?

Electrolux’s sheet prints High Limit Thermostat trip count too high. The control keeps a tally of trips and shows E65 when it passes the allowed number.

What causes the thermostat to trip so often?

The sheet lists a high vent restriction first. A defective thermostat, or a tripped inlet thermal limiter on electric models, follows.

In what order does a technician check E65?

On electric models the inlet limiter’s continuity comes first, then the exhaust system for blockages. Only then is the high-limit thermostat checked, replaced if needed, and the dryer retested.

Is E65 related to EF1?

They share a cause. Both rows put a high vent restriction first, so clearing the vent helps with either. EF1 is the vent-blocked code; E65 counts overheating trips.

Let’s take care of it.

Premium appliances deserve
careful service.