EF1 on an Electrolux dryer means the vent is blocked. The chart calls it vent blocked and the Owner Center guide calls it ventilation blockage, a known installation issue. Clean the lint filter, check the exhaust tube and the vent exit.
EF1 on an Electrolux dryer means the vent is blocked. The chart calls it vent blocked and the Owner Center guide calls it ventilation blockage, a known installation issue. Clean the lint filter, check the exhaust tube and the vent exit.
EF1 on an Electrolux dryer means the vent is blocked. The chart calls it vent blocked and the Owner Center guide calls it ventilation blockage, a known installation issue. Clean the lint filter, check the exhaust tube and the vent exit.
What you can safely check
Pull the screen and remove lint.
When to call a technician
EF1 returns with a clear filter, tube and vent exit.
Your checklist, kept on this device
Safe checks, in order.
0 of 5 checks done
Illustration. Follow your model’s instructions.
Before you begin
Clean the lint filter
Pull the screen and remove lint. The Owner Center guide lists this first, and the lint screen article says to clean it every load. [3]
Illustration. Follow your model’s instructions.
Check 2
Inspect the exhaust tube
Unplug the dryer and pull it out gently. Look for bends, kinks and blocks.
Illustration. Follow your model’s instructions.
Check 3
Clear the vent exit
Check where the vent leaves the house and remove debris. Electrolux says to clear anything in the way.
Illustration. Follow your model’s instructions.
Check 4
Retry a short cycle
With a clear path, run a timed cycle to see whether EF1 returns.
Illustration. Follow your model’s instructions.
Check 5
Book a visit
If EF1 returns with a clear filter, tube and exit, the chart checks the exhaust and inlet thermistors and the control board.
Still showing EF1?
Send us the model and the checks you have done, and open your request here.
Air is not leaving the dryer freely. The chart gives vent blocked; the Owner Center guide gives ventilation blockage and adds that it is a known installation issue.
A high vent restriction first, then the exhaust control thermistor, the inlet control thermistor or the electronic control board. Its solution is to check vent restrictions and the two thermistors' resistance.