Maintenance

Electrolux washer suds: SU dS, F2 and how much detergent is too much

SU dS means the washer detected too many suds. It adds rinses until they clear, about 5 minutes each. Use high efficiency detergent, measure to the max fill line or below, run an empty quick wash afterwards and press Cancel to clear the message.

Thick white foam pressed against the glass of a front-load washer door, with a detergent cap on the counter.
Experienced techniciansWarranty on our workmanshipOEM parts available on orderUpfront pricing, agreed before work
On this page
Key points
  • SU dS adds rinses until the suds clear; each adds about 5 minutes. 1
  • The technician sheet's F2 reads: too much soap or wrong type. 3
  • Powder and liquid detergent go in the main wash cup, below the max fill line. 2
  • A detergent pack goes in the drum before the laundry, never in the dispenser. 2
  • Too much detergent can also slow the drain. 4

What does SU dS mean on an Electrolux washer?#

SU dS means the washer detected oversudsing. It will keep adding rinse cycles until the suds are cleared, and each extra rinse adds about 5 minutes to the cycle. Press Cancel to turn off the alert message; the rinses continue until the suds are gone. 1

It is a protection, not a failure. The Owner Center article lists the same three owner steps every time: use high efficiency detergent, do not use too much, and run an empty cycle on quick wash to clean the unit. 1

The technician sheet describes the same condition with a different label. It lists F2 as too much soap or wrong type, marks it as shown to the user, and tells the technician to advise the customer to reduce detergent or change to high efficiency type. No Electrolux document we read prints the letters EF2, even though people search for it. 3

What does high efficiency detergent do?#

Electrolux says high efficiency detergent is formulated to reduce soap suds and ensure proper cleaning. Check the label for the HE mark before you blame the machine. 2

Electrolux's detergent guide is short, and it covers three forms:

Detergent typeWhere it goesWarning from Electrolux
Powder or liquidThe main wash cup in the dispenserStay below the max fill line 2
Detergent packInto the drum first, then the laundryNever in the dispenser; the gel coating may clog the detergent door 2
Liquid bleach or softenerThe compartment labeled for itUse the matching compartment 2

Putting the pack in first helps the detergent dissolve into the water. The guide says this helps fix the detergent into the water. 2

  1. 1

    Pick a high efficiency detergent#

    Look for the HE mark on the label. Standard detergent can foam past what the washer can rinse out. 2

    Hand holding a white laundry detergent jug with a blank blue label turned toward the camera.
  2. 2

    Measure into the main wash cup#

    Pour powder or liquid into the main wash cup only, and keep the level at or under the max fill line. 2

  3. 3

    Or place a pack in the empty drum#

    Drop the pack in first, then load the laundry over it. Keep it out of the drawer. 2

    Single detergent pod resting at the bottom of an empty stainless front-load washer drum with the door open.
  4. 4

    Use the other compartments for their own items#

    Bleach and softener each go in the compartment marked for them. 2

How do I clear an SU dS message?#

Press Cancel to turn off the alert, let the washer finish its extra rinses and then run an empty cycle on quick wash. Electrolux gives this order. The washer keeps rinsing until the suds are removed, so the cycle time stretches while you wait. 1

If you were mid-cycle with a full load, you do not need to stop it. The rinses are the washer doing the work. What you want to avoid is adding more detergent to a load that is already oversudsed, which makes the next rinse longer. 1

What the empty cycle is for#

Run it with nothing in the drum and no detergent. Electrolux's article says this cleans the unit, and that is all it claims. 1

Can detergent affect other things on the washer?#

Yes. Electrolux says that using too much detergent can inhibit draining, so a slow drain and a suds message can share a cause. Use the recommended amount and never fill a compartment past its maximum line. 4

The slow-drain article is mostly about the drain hose and the standpipe, and it is written about a top-load washer, so we only use its detergent line. The hose and standpipe checks belong to the washer-draining pages, not this guide. 4

Two more places suds can show up:

  • The drawer. A drawer with buildup can leak. Electrolux's leak article says the drawer should be closed and flush with the unit, and points to the manual for cleaning. 5
  • The door. The same article says to clean the rubber seal and glass to remove hair, dirt and lint. A leak there is not a detergent problem, but a dirty seal can hide one. 5
Clear detergent cap holding blue liquid on a laundry counter, a front-load washer blurred behind.
The line in the cup or drawer is the limit.

How do I tell a detergent problem from a washer problem?#

If the washer clears the suds, finishes the cycle and the message stays away when you pour less, the cause was the detergent. If SU dS or F2 returns on a measured HE dose, or the drum stays wet after the cycle, a technician should look at the sensing and drain side. 13

Write down how much detergent you used, which brand, which cycle and how large the load was. That separates a heavy-dose pattern from a real sensing issue, and it gives the technician a place to start.

When do the suds call for a technician?#

Book when SU dS or F2 comes back on properly measured HE detergent, when the drum is still holding water once the cycle ends, or when the drawer or door leaks on a normal load. Say how much detergent you used and which cycle was running. 1345

Next step: \book a visit\, or look over our washer service. The technician agrees the price with you before any work starts. The exact cost is confirmed after the on-site diagnostic. If your unit is under the manufacturer's warranty, the manufacturer handles that repair. We give a warranty on our workmanship.

Sources#

  1. Laundry front loading washer displaying Error Code SU dS too many suds. (KB 1829292)Electrolux / Owner Center knowledge base (owner.electrolux.com) · Owner Center article, cached 10.11.2026 (no edition date printed) · article text
  2. Laundry Washers - Detergent Guide (KB 1834689)Electrolux / Owner Center knowledge base (owner.electrolux.com) · Owner Center article, cached 10.11.2026 (no edition date printed) · article text
  3. Washer Tech Data Sheet, A11200302 (1803)Electrolux (technician sheet; retailer-hosted copy) · A11200302 (1803); 2018, 300/400/500/600 series · p.4 (Washer Error Codes: F2)
  4. What should I do if my washer is draining slowly? (KB 1853030)Electrolux / Owner Center knowledge base (owner.electrolux.com) · Owner Center article, cached 10.11.2026 (no edition date printed) · article text
  5. Laundry front loading washer is leaking water. (KB 1831358)Electrolux / Owner Center knowledge base (owner.electrolux.com) · Owner Center article, cached 10.11.2026 (no edition date printed) · article text

Here to help

Good questions.
Clear answers.

Talk to our team
What does SU dS mean on an Electrolux washer?

The washer detected oversudsing. It adds rinses until the suds clear, and each extra rinse adds roughly 5 minutes to the cycle. Press Cancel to turn off the alert message. [1]

Is F2 the same as SU dS?

They describe the same condition. The technician sheet lists F2 as too much soap or wrong type and tells the technician to advise reducing detergent or changing to high efficiency. SU dS is the wording the Owner Center uses. [1][3]

Can I put a detergent pack in the drawer?

No. Electrolux wants the pack in the empty drum ahead of the laundry, because the gel coating may clog the detergent door if it goes in the dispenser. [2]

Where does liquid bleach go?

Bleach and softener each have a compartment of their own. Powder or liquid detergent goes in the main wash cup, below the max fill line. [2]

Can too much detergent slow the drain?

Electrolux says using too much detergent can inhibit draining, so measure the recommended amount and keep every compartment under its maximum line. [4]

Let’s take care of it.

Premium appliances deserve
careful service.