What it means
E94 is a cycle configuration checksum error on Electrolux's dryer chart: wrong configuration data was loaded or the electronic control board is defective. The solution is to replace the control board. Book a technician.
Electrolux dryer E94 / Control board
E94 is a cycle configuration checksum error on Electrolux's dryer chart: wrong configuration data was loaded or the electronic control board is defective. The solution is to replace the control board. Book a technician.
Also shown as E94
E94 is a cycle configuration checksum error on Electrolux's dryer chart: wrong configuration data was loaded or the electronic control board is defective. The solution is to replace the control board. Book a technician.
Unplug for a minute and plug in again.
E94 returns.
Your checklist, kept on this device

Unplug for a minute and plug in again. If E94 comes straight back, the stored data is wrong.

A control board fitted for a different model fits this code.

The cycle data lives on the control board. There is no owner reset.

The label inside the door shows the model number.

The chart's solution is a new electronic control board.
Send us the model and the checks you have done, and open your request here.
Book a visitA simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.

Component reference
The dryer electronic control board is the main board of an Electrolux front-load dryer, and the interface board is the console board that talks to it.
Read the definitionThe cycle configuration data failed its checksum. The chart reads cycle configuration checksum error.
Read the supporting manualReplace the electronic control board. Unlike E93, the chart does not involve the console.
Read the supporting manualThe chart lists wrong configuration data loaded as the condition, so a board meant for another model fits the pattern.
Read the supporting manualE42 also points to the control board in the chart, but for door sensing. The related-code link is the board.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
P/N 137265000B (1202); Canadian SKU EIMED6CJIW; original file dated 2009 / sheet p.2 (Error Code Chart)
Row E94 of the dryer chart, page 2.
The chart names no power cause for E94. It lists wrong configuration data or a defective control board, which is the board's own stored data.
No. E97 is a program mismatch, while E94 is a cycle configuration checksum error. The chart gives both the same fix, a new control board.
Probably. If the control cannot trust its stored cycle table, it will not run cycles reliably, so expect the dryer to refuse to start.
For E94, the model number and any earlier control board replacement, since a board meant for another model fits this code.
Codes, symptoms, parts and service
E93 is a machine configuration checksum error on Electrolux's dryer chart: the wrong configuration data was loaded, or the interface board, control board or wiring is defective. Book a technician; the chart replaces the interface board and/or console.
Most dryer noise has a simple source: coins or buckles in the drum, a loose pedestal, shipping bolts still in place or a dryer that is out of level. Electrolux also lists sounds that are normal, such as the chime at the end of a cycle.
The dryer electronic control board is the main board of an Electrolux front-load dryer, and the interface board is the console board that talks to it. Electrolux's dryer chart names the control board for E54, E67, E94, E97 and EA5, and the pair for E91 to E93. Owners can restart the dryer once; board work is for a technician.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.