What it means
EA5 is a main voltage sensing failure on Electrolux's dryer chart. The only listed condition is a defective electronic control board, and the solution is to replace it. Book a technician.
Electrolux dryer EA5 / Power supply
EA5 is a main voltage sensing failure on Electrolux's dryer chart. The only listed condition is a defective electronic control board, and the solution is to replace it. Book a technician.
Also shown as EA5
EA5 is a main voltage sensing failure on Electrolux's dryer chart. The only listed condition is a defective electronic control board, and the solution is to replace it. Book a technician.
Unplug for a minute and plug in.
EA5 returns after a restart.
Your checklist, kept on this device

Unplug for a minute and plug in. A one-off sensing glitch may clear.

Confirm the plug is tight and no extension cord is used. A good supply rules out the line.

The board uses its voltage reading to run the dryer.

Wake with any button except Cancel and hold Cancel and Start/Pause for 6 seconds.

The chart's solution is to replace the electronic control board.
Send us the model and the checks you have done, and open your request here.
Book a visitA simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.

Component reference
The dryer electronic control board is the main board of an Electrolux front-load dryer, and the interface board is the console board that talks to it.
Read the definitionThe control cannot sense the main supply voltage. The chart reads main V sensing failure with the control board defective.
Read the supporting manualThe sensing circuit is on the board itself, so there is no wiring or supply step before replacement.
Read the supporting manualEA2 and EA3 say the voltage is too high or low. EA5 says the dryer cannot measure it.
Read the supporting manualIt may run, but a dryer that cannot sense its supply may misbehave.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
P/N 137265000B (1202); Canadian SKU EIMED6CJIW; original file dated 2009 / sheet p.2 (Error Code Chart)
Row EA5 of the dryer chart, page 2.
No. The chart lists only the control board for EA5. A bad supply shows up as EA1, EA2 or EA3 instead.
Only if it was a one-off sensing glitch. A defective board repeats EA5 when the dryer next runs.
We give no prices here; the chart's solution is a new control board.
For EA5, the model number and what the dryer did when the code appeared, such as stopping at start or partway through.
Codes, symptoms, parts and service
EA2 means the line voltage is too high, per Electrolux's dryer chart. The conditions are high line voltage or a faulty control board, and the chart's step is to check the amplitude of the line voltage. Unplug the dryer and book a technician.
Most dryer noise has a simple source: coins or buckles in the drum, a loose pedestal, shipping bolts still in place or a dryer that is out of level. Electrolux also lists sounds that are normal, such as the chime at the end of a cycle.
The dryer electronic control board is the main board of an Electrolux front-load dryer, and the interface board is the console board that talks to it. Electrolux's dryer chart names the control board for E54, E67, E94, E97 and EA5, and the pair for E91 to E93. Owners can restart the dryer once; board work is for a technician.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.