F10 on an Electrolux oven is a runaway temperature alert. Turn the oven off, leave the door shut and let it cool. The Owner Center guide calls it a built-in safety alert, and the technician sheets tie it to a shorted relay or a bad temperature probe.
F10 on an Electrolux oven is a runaway temperature alert. Turn the oven off, leave the door shut and let it cool. The Owner Center guide calls it a built-in safety alert, and the technician sheets tie it to a shorted relay or a bad temperature probe.
Service Data Sheet, p/n 807436903, "Appliance with ES630 Electronic Oven Control" (EW30EW65PS)
What Electrolux oven F10 means.
What it means
F10 on an Electrolux oven is a runaway temperature alert. Turn the oven off, leave the door shut and let it cool. The Owner Center guide calls it a built-in safety alert, and the technician sheets tie it to a shorted relay or a bad temperature probe.
What you can safely check
F10 means the oven sensed temperatures higher than expected.
When to call a technician
F10 returns, or the oven stays hot after you switch it off.
Your checklist, kept on this device
Safe checks, in order.
0 of 5 checks done
Illustration. Follow your model’s instructions.
Before you begin
Turn the oven off
Switch it off at the controls, and at the breaker if it keeps heating. Leave the door shut so heat stays inside.
Illustration. Follow your model’s instructions.
Check 2
Let it cool fully
Electrolux says to allow the oven to cool before you use it again. Do not open the door to speed it up.
Illustration. Follow your model’s instructions.
Check 3
Check the Pizza Shield rack
On Stone-Baked Pizza ovens, F10 can come from the Pizza Shield on the wrong rack. Confirm the rack and shield are in position 7, then reset and preheat again. [6]
Illustration. Follow your model’s instructions.
Check 4
Reset the power
Unplug the oven or flip the breaker for 30 seconds, then restore power. [6]
Illustration. Follow your model’s instructions.
Check 5
Book a visit
If F10 returns, the sheets check the oven temperature probe (RTD) and then replace the relay board and/or display board.
Still showing F10?
Send us the model and the checks you have done, and open your request here.
The oven detected a temperature above the maximum safe operating temperature, or a condition that looks like runaway heating. Electrolux calls it a built-in safety alert.
ES630: the control may have a shorted relay or a bad RTD probe; check the probe and, if the oven keeps overheating, replace the relay board and/or display board. Modular: if overheating, disconnect power, check the RTD, then replace the oven relay board.
An oven that heats without control is a fire risk. If the oven is still hot after you switch it off, cut power at the breaker and keep the door closed.
Only after it has cooled and a reset has cleared the code. If F10 returns, stop using it until a technician has checked the probe and relay.
Does F10 mean the oven is on fire?
No. It means the control saw a temperature or reading it considers unsafe. Switch off and look for smoke or flames; if you see any, cut power and call emergency services.
Why does the pizza oven matter?
Electrolux says the Pizza Shield in the wrong rack position can trigger F10 on Stone-Baked Pizza ovens.
Before booking F10, what helps?
For F10, the model number, whether you were baking, using self-clean or the pizza function, and what the oven did when F10 showed.