What it means
F33 means the meat probe temperature sensor is shorted or too hot, on Electrolux's modular wall oven control. The sheet gives 392 degrees F as the trigger. Check the probe is fully inserted into the socket and its tip is in the food.
Electrolux oven F33 / Meat probe
F33 means the meat probe temperature sensor is shorted or too hot, on Electrolux's modular wall oven control. The sheet gives 392 degrees F as the trigger. Check the probe is fully inserted into the socket and its tip is in the food.
Also shown as F33
F33 means the meat probe temperature sensor is shorted or too hot, on Electrolux's modular wall oven control. The sheet gives 392 degrees F as the trigger. Check the probe is fully inserted into the socket and its tip is in the food.
Remove the meat probe from the socket once the oven is cool and wipe it dry.
F33 returns with a fully inserted probe.
Your checklist, kept on this device

Remove the meat probe from the socket once the oven is cool and wipe it dry.

The sheet says a probe that is not fully inserted can short the contacts. Push it in as far as it goes next time.

If the tip is outside the meat, the probe sees the cavity temperature, which can exceed 392 degrees F and trigger the alarm.

Run a normal bake with the meat probe unplugged. If F33 stays away, the probe or its use was the cause.
The sheet compares the probe's resistance with a chart, replaces the probe if it differs, then the relay board.
Send us the model and the checks you have done, and open your request here.
Book a visit
A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
The meat probe circuit shows a short, or a temperature above 392 degrees F.
Read the supporting manualThat the probe was not used so that its tip saw more than 392 degrees F, and that it was fully inserted into the oven socket.
Read the supporting manualThe sheet's chart gives 50.02 kilohms at 77 F, 18.02 at 122 F, 6.29 at 176 F and 3.4 at 212 F. A probe that does not match is replaced.
Read the supporting manualThe sheet ties it to the meat probe. Baking without the probe may be unaffected, but we cannot say.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
Models: EI30EW38TS
p/n A00980644 Rev A (2017/05) / PDF p.1
Row F33 of the 2017 modular-control sheet, modular oven controls. The 392 degrees F trigger and the probe resistance chart come from that sheet.
The sheet names no dirt, but a probe or socket with food on it is worth cleaning.
F30 and F31 are the oven's own temperature probe. F33 is the meat probe.
Only if its resistance does not match the sheet's chart. A probe that was simply not fully inserted may be fine once it is seated properly.
For F33, the model number, which probe you used and whether F33 appeared at the start of a roast.
Codes, symptoms, parts and service
F30 is an open oven temperature probe (RTD) or its wiring, on both Electrolux oven controls. Reset the power by unplugging for 30 seconds. The ES630 sheet adds that the control may show F10 first. If F30 returns, book a technician.
The written Electrolux articles say little about setting the clock or timer, since its display-settings guide is a video. What they do cover is a display or keypad that acts up: a stuck key (F11), memory and cable errors (F13, F14, F15), Demo mode and a power reset.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.