What it means
E83 is a wrong selector reading on Electrolux's 2018 washer sheet: the control read the cycle selector in a position it does not recognize. The display does not show E83. Turn the selector once and book a technician if it returns.
Electrolux washer E83 / Control board
E83 is a wrong selector reading on Electrolux's 2018 washer sheet: the control read the cycle selector in a position it does not recognize. The display does not show E83. Turn the selector once and book a technician if it returns.
Also shown as E83
E83 is a wrong selector reading on Electrolux's 2018 washer sheet: the control read the cycle selector in a position it does not recognize. The display does not show E83. Turn the selector once and book a technician if it returns.
Move the cycle selector to a different position and back, making sure it clicks into each place.
E83 returns after a power cycle or the selector will not register.
Your checklist, kept on this device

Move the cycle selector to a different position and back, making sure it clicks into each place. Then power the washer off and on.

Press each button on the panel once and see whether any feels jammed or stays down.

Wipe moisture or detergent off the console with a dry cloth, with the washer unplugged.

If E83 appears only at one setting, say so when you book.

The sheet sends E83 to the communication test: wiring between the main and motor control boards, then the boards themselves.
Send us the model and the checks you have done, and open your request here.
Book a visit

A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
The main board saw a selector value that does not match any known position. The sheet describes it as wrong selector reading and does not show it on the display.
Read the supporting manualThe sheet points E83 to test 10, the same wiring check used for motor control communication. The technician starts with the connection between the main board and the motor control board.
Read the supporting manualIf it responds to every setting after a reset, yes. If a cycle will not start or jumps positions, stop and book.
Read the supporting manualThe sheet shows a push-button console and a knob console. Mention which you have, since the sensing differs.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
A11200302 (1803); 2018, 300/400/500/600 series (EFLS527UTT and EFLS627UTT copies are byte-identical) / p.2 (Washer Error Codes)
Row 83 of the 2018 washer sheet: test 10. The sheet shows both knob and button consoles.
Not necessarily. The row concerns the reading, and the sheet's test is wiring first.
It may after a power cycle, but a repeat needs a visit.
No. For E83 the sheet's display column says no, so you would see odd cycle behavior or a stop instead of a message.
For E83, the model, the console style and which setting was active.
Codes, symptoms, parts and service
E86 on Electrolux's 2018 washer sheet is an incorrect user interface selection table: the control panel and main board disagree about the available options. The display does not show E86. Book a technician; the sheet checks the panel wiring.
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.