What it means
E88 is a concentrated wash pump triac alarm on Electrolux's 2018 washer sheet, for select models. The display does not show E88. Book a technician; the sheet checks the pump's wiring, the pump and then the main board.
Electrolux washer E88 / Pump
E88 is a concentrated wash pump triac alarm on Electrolux's 2018 washer sheet, for select models. The display does not show E88. Book a technician; the sheet checks the pump's wiring, the pump and then the main board.
Also shown as E88
E88 is a concentrated wash pump triac alarm on Electrolux's 2018 washer sheet, for select models. The display does not show E88. Book a technician; the sheet checks the pump's wiring, the pump and then the main board.
Concentrated wash pumps appear on select models.
E88 is stored again after a restart.
Your checklist, kept on this device

Concentrated wash pumps appear on select models. The model label tells you which sheet row applies.

The pump circuit is line voltage. Disconnect power before opening the door or draining.

The alarm happens when the control calls for the pump, so the stage helps.

Wait ten seconds after power-up, hold Temp and Select three seconds.

Test 22 follows the wiring to the pump, then the pump, then the main board.
Send us the model and the checks you have done, and open your request here.
Book a visit
A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
The control raised an alarm on the switch that powers the concentrated wash pump. The sheet reads concentrated wash pump triac alarm (on select models).
Read the supporting manualIt checks the wiring to the concentrated wash pump. A bad wire is corrected. Good wiring leads to replacing the pump and, if the code remains, the main control board.
Read the supporting manualThey are sister rows for two different pumps, with the same test pattern: wiring, pump, board.
Read the supporting manualIf the washer completes cycles, yes. A repeat alarm that stops a cycle means book.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
A11200302 (1803); 2018, 300/400/500/600 series (EFLS527UTT and EFLS627UTT copies are byte-identical) / p.2 (Washer Error Codes)
Row 88 of the washer sheet: select models. Test 22.
A pump on select models that moves a concentrated mix of water and detergent. The sheet does not describe it further.
The sheet names no detergent cause for E88. It treats it as an electrical alarm on the pump's switch.
No. For E88 the sheet's display column says no, so it is something you recall from the stored errors.
No. It is an electrical alarm, not a water problem. Water on the floor would be a different row such as E13.
Codes, symptoms, parts and service
E84 is a recirculation pump triac sensing failure that stops the cycle, on Electrolux's 2018 washer sheet (select models). The display does not show E84. The sheet's next step is to replace the main board, so book a technician.
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.