What it means
E93 is a console or main board control problem on Electrolux's 2018 washer sheet: an incompatible machine configuration. The display shows it. Power-cycle once and book a technician; the sheet checks the wiring between the boards.
Electrolux washer E93 / Control board
E93 is a console or main board control problem on Electrolux's 2018 washer sheet: an incompatible machine configuration. The display shows it. Power-cycle once and book a technician; the sheet checks the wiring between the boards.
Also shown as E93
E93 is a console or main board control problem on Electrolux's 2018 washer sheet: an incompatible machine configuration. The display shows it. Power-cycle once and book a technician; the sheet checks the wiring between the boards.
Unplug for a minute, plug in and see whether it starts normally.
E93 stays after a restart.
Your checklist, kept on this device

Unplug for a minute, plug in and see whether it starts normally.

E93 is displayed, so note the exact characters.

A board that does not match the machine's configuration can produce E93.

With the configuration in doubt, do not start a wash you cannot stop.

Test 11 checks the interface wiring and then replaces the interface board and, if needed, the main board.
Send us the model and the checks you have done, and open your request here.
Book a visit
A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.

Component reference
The main control board runs an Electrolux front-load washer and talks to the user interface and the motor control.
Read the definitionThe washer's configuration data does not fit the machine, according to the sheet: console or main board control problem (incompatible machine configuration).
Read the supporting manualThe sheet's display column says yes for E93, because an incompatible configuration affects what the washer can do.
Read the supporting manualTest 11: wiring between the main and interface boards first, then the interface board, then the main board.
Read the supporting manualYes: these are the configuration family. E94 and E97 concern the cycle configuration.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
A11200302 (1803); 2018, 300/400/500/600 series (EFLS527UTT and EFLS627UTT copies are byte-identical) / p.2 (Washer Error Codes)
Row 93 of the washer sheet: shown on the display; test 11.
It means the boards do not match the machine's setup. Whether that is wiring or a part is for the visit.
A reset may clear the message, but if the mismatch remains the code returns.
The sheet names no surge cause for E93, so we cannot say. It points to board compatibility and wiring.
For E93, the model number, the exact message on the display and any board or panel work done before.
Codes, symptoms, parts and service
E94 is a main board control problem, an incompatible cycle configuration, on Electrolux's 2018 washer sheet. The display shows it. Power-cycle once and book a technician; the sheet checks the wiring between the main and motor control boards.
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
The main control board runs an Electrolux front-load washer and talks to the user interface and the motor control. Electrolux's washer sheet names it for E91 to E94, E97 and E98, and for E84 where it says to replace the main board. The first step is one restart.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.