What it means
HE or BE is a control relay failure on Electrolux's 2018 washer sheet. The display does not show HE/BE. Unplug the washer and book a technician; the sheet's test 18 checks the supply, the wiring to the board and then the board.
Electrolux washer HE/BE / Control board
HE or BE is a control relay failure on Electrolux's 2018 washer sheet. The display does not show HE/BE. Unplug the washer and book a technician; the sheet's test 18 checks the supply, the wiring to the board and then the board.
Also shown as HE/BE
HE or BE is a control relay failure on Electrolux's 2018 washer sheet. The display does not show HE/BE. Unplug the washer and book a technician; the sheet's test 18 checks the supply, the wiring to the board and then the board.
A control relay problem sits on the main board, which carries line voltage.
HE or BE is stored again.
Your checklist, kept on this device

A control relay problem sits on the main board, which carries line voltage. Leave it unplugged until it has been checked.

Relays switch loads like pumps and valves on. Which stage the washer stopped at helps the visit.

A tight plug and a healthy outlet are first checks. Do not use an extension cord.

With the washer on, wait about ten seconds and press and hold Temp plus Select for three seconds.

The sheet checks supply under load, then the board wiring, then replaces the main board.
Send us the model and the checks you have done, and open your request here.
Book a visit

A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
A relay on the main control did not operate as the control expects. The sheet states control relay failure, with no display notification.
Read the supporting manualTest 18: power in under load, power wiring to the main board, wiring to the motor board for a short to power or ground, then replace the main board.
Read the supporting manualHF/BF is the control relay sense failure, where the control cannot confirm what the relay is doing. HE/BE is the relay itself.
Read the supporting manualIf it completes cycles, with care. If it stops or trips breakers, stop.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
A11200302 (1803); 2018, 300/400/500/600 series (EFLS527UTT and EFLS627UTT copies are byte-identical) / p.2 (Washer Error Codes)
Row HE/BE of the washer sheet: stored only; test 18.
An electrically operated switch on the board that turns the washer's loads on and off.
No. The sheet marks HE/BE as not shown, so a stalled cycle is the first sign and the stored-error recall confirms it.
It clears the message. The code returns if the relay still misbehaves.
For HE/BE, the model, the cycle stage and any power problems nearby.
Codes, symptoms, parts and service
HF or BF is a control relay sense failure on Electrolux's 2018 washer sheet: the control cannot confirm what its relay is doing. The display does not show HF/BF. Unplug the washer and book a technician for test 18.
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.