What it means
F45 means the cooling fan speed is too low on Electrolux's modular wall oven control. The ES630 prints F43 for the same condition. Check the fan blades are not blocked, then book a technician.
Electrolux oven F45 / Cooling fan
F45 means the cooling fan speed is too low on Electrolux's modular wall oven control. The ES630 prints F43 for the same condition. Check the fan blades are not blocked, then book a technician.
Also shown as F45
F45 means the cooling fan speed is too low on Electrolux's modular wall oven control. The ES630 prints F43 for the same condition. Check the fan blades are not blocked, then book a technician.
Make sure the vent area is clear and no item blocks airflow.
F45 returns or the fan is silent.
Your checklist, kept on this device

Make sure the vent area is clear and no item blocks airflow.

Turn the breaker off, count to 30 and switch it on again.

Is the fan running, slow or silent? Tell us which.

The fan and its tachometer harness sit behind panels.

The sheet checks the blades for blockage, confirms the tachometer harness at the fan and the oven control, then replaces the fan and the oven control.
Send us the model and the checks you have done, and open your request here.
Book a visit
A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.

Component reference
The cooling fan keeps the oven’s outer cabinet from overheating.
Read the definitionThe oven's cooling fan speed is below what the control expects.
Read the supporting manualCheck whether the fan blades are blocked, confirm the tachometer harness is connected on the fan and on the oven control, replace the cooling fan, then replace the oven control.
Read the supporting manualSame condition, different control: F43 is on the ES630 and F45 on the modular control.
Read the supporting manualNot for long. The cooling fan protects the electronics from heat.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
Models: EI30EW38TS
p/n A00980644 Rev A (2017/05) / PDF p.1
Row F45 of the 2017 modular-control sheet, modular oven controls.
No. F46 is a cooling fan running too fast, while F45 is one running too slow. Both are modular control rows.
The sheet checks for blocked blades. It does not name dust.
It can be, because the tachometer harness is on the sheet's list.
For F45, the model number and whether the fan is audible or silent when the oven runs.
Codes, symptoms, parts and service
F46 means the cooling fan speed is too high on Electrolux's modular wall oven control. The ES630 prints F44 for the same condition. Check for an obstruction in the air path, then book a technician.
The written Electrolux articles say little about setting the clock or timer, since its display-settings guide is a video. What they do cover is a display or keypad that acts up: a stuck key (F11), memory and cable errors (F13, F14, F15), Demo mode and a power reset.
The cooling fan keeps the oven’s outer cabinet from overheating. The ES630 sheet reads its speed through a tachometer: F43 means too slow and F44 too fast. The 2017 modular sheet uses F45 for too low and F46 for too high.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.