What it means
The washer has paused because it detected an item pinched between its door and the gasket, and the display loops CLEAr door under a chime. Press Cancel to release the door, take the item out, close up and restart the cycle.
Electrolux washer CLEAr door / Door and lid lock
The washer has paused because it detected an item pinched between its door and the gasket, and the display loops CLEAr door under a chime. Press Cancel to release the door, take the item out, close up and restart the cycle.
Also shown as CLEAr door
The washer has paused because it detected an item pinched between its door and the gasket, and the display loops CLEAr door under a chime. Press Cancel to release the door, take the item out, close up and restart the cycle.
The message loops until you do.
CLEAr door appears with nothing trapped in the door seal.
Your checklist, kept on this device

The message loops until you do. Cancel also unlocks the door.

Look around the gasket for a sock, a sleeve or a strap.

Run a finger around the seal first to be sure nothing is caught.

Begin the cycle again once the door closes.
Send us the model and the checks you have done, and open your request here.
Book a visitA simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
A sensor found something caught where the door meets the gasket. The cycle is on hold and a chime plays.
Read the supporting manualPress Cancel to unlock the door and remove the trapped item. Close the door and restart.
Read the supporting manualNot necessarily. The check protects the seal and the load.
Read the supporting manualManufacturer document
Electrolux
A20448609-A-172025 / PDF p.32 (Trapped item detection)
Electrolux front-load washer User Manual A20448609 (300 to 700 series).
No. E41 means the door is open; here the door is shut on something.
Check the drum before opening.
Garments can work out around the door during loading. Tuck them in.
When CLEAr door shows although the seal is empty.
Codes, symptoms, parts and service
E41 on an Electrolux front-load washer means the control thinks the door switch is open. Check the door is fully closed, nothing is caught in it, and you hear a click. The latch and striker must work. If it persists, book a technician.
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.