What it means
E38 on an Electrolux front-load washer means the air trap is clogged. The display does not show E38. Book a technician; the air trap sits behind the tub with the pressure sensor, and the sheet lists no owner step.
Electrolux washer E38 / Water level
E38 on an Electrolux front-load washer means the air trap is clogged. The display does not show E38. Book a technician; the air trap sits behind the tub with the pressure sensor, and the sheet lists no owner step.
Also shown as E38
E38 on an Electrolux front-load washer means the air trap is clogged. The display does not show E38. Book a technician; the air trap sits behind the tub with the pressure sensor, and the sheet lists no owner step.
Power up, pause ten seconds, then hold the Temp and Select buttons together for a count of three.
E38 returns, or the washer fills to a clearly wrong level.
Your checklist, kept on this device

Power up, pause ten seconds, then hold the Temp and Select buttons together for a count of three. The display shows the last stored error.

The sheet names no soap cause, so we do not either. Do note whether the washer showed SU dS or heavy suds lately.

If the tub floods or starts a cycle with little water, mention it. The air trap passes tub pressure to the sensor.

Pulling on the air path can open a leak. Unplug the washer and keep the cabinet closed.

Test 5 checks the air trap when the water does not enter continuously. We clear or replace it on site.
Send us the model and the checks you have done, and open your request here.
Book a visitA simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
It is the passage that carries tub pressure to the pressure sensor so the control knows the water level. The sheet's wording for E38 is air trap clogged.
Read the supporting manualWhen the water level is under 4.5 inches, the sheet replaces the pressure sensor switch first. When the tub level is high and water is not entering continuously, it checks the air trap for a clog.
Read the supporting manualYes, through the same test. E35 reads overfill, E38 reads a clog in the path that feeds the level reading.
Read the supporting manualA blocked level path can give wrong readings, so avoid unattended cycles until it has been checked.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
A11200302 (1803); 2018, 300/400/500/600 series (EFLS527UTT and EFLS627UTT copies are byte-identical) / p.1 (Washer Error Codes)
Row 38 of the 2018 front-load washer sheet (the washer sheet), tested with E35 under test 5. Not a displayed code.
The sheet does not say, so we cannot name a cause. It lists the air trap as a thing to check for a clog, not a reason it clogs.
Not necessarily. The sheet checks the air trap before replacing the control board in that branch.
No. For E38 the sheet's display column says no, so the stored error recall is how you confirm it was the last code.
The model number, the stored code and whether the water in the tub looked too high, too low or normal during the cycle.
Codes, symptoms, parts and service
E31 on an Electrolux front-load washer is an electronic pressure switch error on the technician sheet, and the display does not show it. Owners have no safe fix beyond reading the stored code, so book a technician.
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.