What it means
E43 on an Electrolux front-load washer is a door lock triac failure on the technician sheet, which does not show it on the display. First confirm the door closes properly; otherwise book a technician.
Electrolux washer E43 / Door
E43 on an Electrolux front-load washer is a door lock triac failure on the technician sheet, which does not show it on the display. First confirm the door closes properly; otherwise book a technician.
Also shown as E43
E43 on an Electrolux front-load washer is a door lock triac failure on the technician sheet, which does not show it on the display. First confirm the door closes properly; otherwise book a technician.
Make sure it latches with a click and nothing is caught.
E43 is stored again or the door will not lock.
Your checklist, kept on this device

Make sure it latches with a click and nothing is caught. Test 6 starts with the door being closed.

The sheet asks whether you can hear the lock attempt to close. Write down whether you did.

Switch the washer on, let ten seconds pass, then press Temp and Select together and keep them down for three seconds to confirm E43.

The lock is wired to the main board with line voltage. Unplug first and leave connectors to a technician.

The sheet replaces the lock, then the main board if needed.
Send us the model and the checks you have done, and open your request here.
Book a visit
A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.

Component reference
The door lock keeps the washer closed during a cycle and tells the control the door is shut.
Read the definitionThe electronic switch on the control board that powers the door lock. E43 says that switch has failed, according to the sheet.
Read the supporting manualE42 is the lock not being recognized. E43 concerns the board's switching of the lock. They share test 6, so the on-site work is the same.
Read the supporting manualOnly that the door closes and the latch and striker look intact. The rest of test 6 is wiring and parts.
Read the supporting manualIf the door cannot be locked, the control will refuse to run the cycle.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
A11200302 (1803); 2018, 300/400/500/600 series (EFLS527UTT and EFLS627UTT copies are byte-identical) / p.1 (Washer Error Codes)
Row 43 of the 2018 front-load washer sheet (the washer sheet), tested under test 6 together with E41, E42, E44 and E45.
The sheet lists the lock after the strike and wiring checks, so it is possible but not certain.
No. The sheet marks E43 as not displayed, so the stored-error recall is the way to confirm it.
Unplugging only clears the message. If the lock circuit's switch has failed, the code is stored again as soon as the lock is called on.
The model number, the stored code and whether you heard the lock click when you started a cycle.
Codes, symptoms, parts and service
E42 on an Electrolux front-load washer means the door lock is not being recognized. Make sure the door is fully closed, nothing is in the way, you hear a click, and the latch and striker work. If not, book a technician.
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
The door lock keeps the washer closed during a cycle and tells the control the door is shut. Electrolux’s sheet lists five door codes. E41 means the board thinks the door switch is open; E42 and E43 are about the lock itself; E44 and E45 about sensing.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.