What it means
E44 on an Electrolux front-load washer is a door closed sensing failure on the technician sheet. The display does not show E44. Check the door is shut and clear of debris, then book a technician.
Electrolux washer E44 / Door
E44 on an Electrolux front-load washer is a door closed sensing failure on the technician sheet. The display does not show E44. Check the door is shut and clear of debris, then book a technician.
Also shown as E44
E44 on an Electrolux front-load washer is a door closed sensing failure on the technician sheet. The display does not show E44. Check the door is shut and clear of debris, then book a technician.
Close it slowly until it clicks, then start a short cycle.
E44 recurs after the door is cleared and re-closed.
Your checklist, kept on this device

Close it slowly until it clicks, then start a short cycle.

Look for lint, a stray sock or pet hair stuck in the opening.

The striker on the door should be straight and snug. A loose one can leave the sensor unconfirmed.

Power, wait 10 seconds, then hold Temp and Select for 3 seconds.

Beyond closing the door, test 6 inspects the lock wiring and may replace parts.
Send us the model and the checks you have done, and open your request here.
Book a visit
A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.

Component reference
The door lock keeps the washer closed during a cycle and tells the control the door is shut.
Read the definitionThe washer's way of sensing a closed door has failed, not necessarily the door. The sheet words it as door closed sensing failure.
Read the supporting manualTest 6 covers all door and lock rows: is the door closed, can you hear the lock try, is the strike good, is the wiring from the lock to the main board good.
Read the supporting manualE45 is line door sensing, E44 is door closed sensing. Both are electrical rows that you cannot tell apart from the outside.
Read the supporting manualDo not bypass the door sensing. If the washer will not start, leave it.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
A11200302 (1803); 2018, 300/400/500/600 series (EFLS527UTT and EFLS627UTT copies are byte-identical) / p.1 (Washer Error Codes)
Row 44 of the 2018 front-load washer sheet (the washer sheet), in the door group with E41 to E45 under test 6.
No. E41 says that. E44 means the sensing of closure failed.
For E44 the sheet's display column says no. You will most likely see a washer that will not start or lock.
The sheet gives no owner cleaning step. Wipe the door seal and frame, but leave the sensing parts behind the panel to a technician.
If the washer will not start or lock the door, book now. If it runs normally after a restart, you can wait for a convenient slot.
Codes, symptoms, parts and service
E45 on an Electrolux front-load washer is a line door sensing failure on the technician sheet, and the display does not show it. Make sure the door closes cleanly, then book a technician.
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
The door lock keeps the washer closed during a cycle and tells the control the door is shut. Electrolux’s sheet lists five door codes. E41 means the board thinks the door switch is open; E42 and E43 are about the lock itself; E44 and E45 about sensing.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.