What it means
E45 on an Electrolux front-load washer is a line door sensing failure on the technician sheet, and the display does not show it. Make sure the door closes cleanly, then book a technician.
Electrolux washer E45 / Door
E45 on an Electrolux front-load washer is a line door sensing failure on the technician sheet, and the display does not show it. Make sure the door closes cleanly, then book a technician.
Also shown as E45
E45 on an Electrolux front-load washer is a line door sensing failure on the technician sheet, and the display does not show it. Make sure the door closes cleanly, then book a technician.
Shut the door until you hear a firm click, and check that the latch and the striker meet squarely.
E45 is stored again after you re-close the door.
Your checklist, kept on this device

Shut the door until you hear a firm click, and check that the latch and the striker meet squarely.

Look for anything caught between the door and the frame.

Do not open the cabinet. The sheet's check is the wiring between the lock and the main board.

Power, wait 10 seconds, then hold Temp and Select for 3 seconds.

Test 6 checks the wiring and replaces parts in turn. Give us the model number and the stored code when you book.
Send us the model and the checks you have done, and open your request here.
Book a visit
A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.

Component reference
The door lock keeps the washer closed during a cycle and tells the control the door is shut.
Read the definitionLine door sensing failure: the control cannot read the door signal on its line. The sheet lists it with the other door rows.
Read the supporting manualTest 6: door closed, lock tries to engage, strike intact, wiring between lock and main board good, then lock and board.
Read the supporting manualThey differ in what is sensed. For you they look alike: the washer will not run or lock.
Read the supporting manualStill book a visit, since the sheet's later steps are inside the cabinet.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
A11200302 (1803); 2018, 300/400/500/600 series (EFLS527UTT and EFLS627UTT copies are byte-identical) / p.1 (Washer Error Codes)
Row 45 of the 2018 front-load washer sheet (the washer sheet); door group under test 6.
For E45 the sheet's display column says no. It is a code you find by recalling the stored error, not one the washer announces.
The sheet names no cause beyond its test, so we cannot say. Clearing the doorway is still a harmless first step.
Only if the door latches and locks normally and the cycle runs to the end. If it stops or refuses to start, leave it off.
The model number, the stored code and whether the door clicked shut. Add any other door codes such as E41 or E44 you have seen.
Codes, symptoms, parts and service
E44 on an Electrolux front-load washer is a door closed sensing failure on the technician sheet. The display does not show E44. Check the door is shut and clear of debris, then book a technician.
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
The door lock keeps the washer closed during a cycle and tells the control the door is shut. Electrolux’s sheet lists five door codes. E41 means the board thinks the door switch is open; E42 and E43 are about the lock itself; E44 and E45 about sensing.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.