What it means
E74 on the 2018 Electrolux washer sheet means the wash temperature does not increase. The display does not show E74. Cold cycles may still run; a technician checks the water temperature sensor and the heater.
Electrolux washer E74 / Heating
E74 on the 2018 Electrolux washer sheet means the wash temperature does not increase. The display does not show E74. Cold cycles may still run; a technician checks the water temperature sensor and the heater.
Also shown as E74
E74 on the 2018 Electrolux washer sheet means the wash temperature does not increase. The display does not show E74. Cold cycles may still run; a technician checks the water temperature sensor and the heater.
Sanitize and hot options heat; Cold and Tap Cold do not.
E74 repeats with hot supply and correct hoses.
Your checklist, kept on this device

Sanitize and hot options heat; Cold and Tap Cold do not. Confirm the setting before you suspect the washer.

If your hot water at the tap is only lukewarm, the washer has less to work with.

Hot belongs on the hot inlet. Swapped hoses make hot cycles cold.

Power on, wait ten seconds, hold Temp and Select for three seconds.

Tests 13 and 14 cover the sensor and the heater.
Send us the model and the checks you have done, and open your request here.
Book a visit
A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.

Component reference
On select Electrolux front-load washers, an internal tub heater warms the wash water, and a temperature sensor (NTC) watches it.
Read the definitionDuring a heated cycle the water temperature did not rise. The sheet states wash temperature does not increase.
Read the supporting manualHot water at the house supply and the hose connections. The sheet does not list them, but they affect results.
Read the supporting manualTest 13 measures the water NTC, then test 14 measures the element and ground leakage, then wiring and the main board.
Read the supporting manualE62 is water too hot; E74 is water not heating enough. They share both tests.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
A11200302 (1803); 2018, 300/400/500/600 series (EFLS527UTT and EFLS627UTT copies are byte-identical) / p.2 (Washer Error Codes)
Row 74 of the washer sheet: select models. Tests 13 and 14.
It can be, if the hot supply reaching the washer is cold. Run a hot tap nearby to check before booking.
Often yes, since cold cycles do not call for the heater. The code only tells you the heated part is in doubt.
No. The sheet's display column says no, so recall the stored error to confirm it.
No. E69 is an open heater circuit, which is one way to end up with E74. E74 describes the result: the water never warms.
Codes, symptoms, parts and service
E62 on the 2018 Electrolux washer sheet means the wash temperature went too high. The display does not show E62. Stop the cycle, unplug the washer and book a technician; the sheet sends it to the temperature sensor and heater tests.
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
On select Electrolux front-load washers, an internal tub heater warms the wash water, and a temperature sensor (NTC) watches it. Electrolux's washer sheet names the heater for E66, E68 and E69, and the sensor for E71. Cold cycles may still run; the heater tests are for a technician.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.