What it means
H2 or B2 means the supply voltage is too high, according to Electrolux's 2018 washer sheet. The display shows it. Unplug the washer and book a technician; the sheet has the incoming voltage checked under load first.
Electrolux washer H2/B2 / Power supply
H2 or B2 means the supply voltage is too high, according to Electrolux's 2018 washer sheet. The display shows it. Unplug the washer and book a technician; the sheet has the incoming voltage checked under load first.
Also shown as H2/B2
H2 or B2 means the supply voltage is too high, according to Electrolux's 2018 washer sheet. The display shows it. Unplug the washer and book a technician; the sheet has the incoming voltage checked under load first.
High voltage can damage the control and motor.
H2 or B2 appears again.
Your checklist, kept on this device

High voltage can damage the control and motor. Keep it off until the supply is checked.

Lights that run bright, bulbs burning out and other electronics acting up suggest a supply problem at the house.

We do not open panels. If you suspect the home wiring, ask an electrician or the utility.

The sheet prints H2/B2. Note which one appears.

Test 18 starts with voltage under load, then power wiring to the main board, then a short check to the motor board, then the main board.
Send us the model and the checks you have done, and open your request here.
Book a visitA simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
The incoming voltage is above the control's limit. The sheet's wording is supply voltage too high (incoming voltage), and the display shows it.
Read the supporting manualThe sheet describes both as supply voltage too high and sends both to test 18. It does not say how they differ, so we do not guess.
Read the supporting manualThe power in, under load, and any supply or branch-circuit issue. Only after that does it look at the wiring and the main board.
Read the supporting manualDo not run the washer on a supply you suspect is high.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
A11200302 (1803); 2018, 300/400/500/600 series (EFLS527UTT and EFLS627UTT copies are byte-identical) / p.2 (Washer Error Codes)
Row H2/B2 of the washer sheet: shown on the display. Test 18.
The sheet does not address that, and a power strip adds resistance. Plug straight into a wall outlet.
Yes: the main board could be misreading, which is the last step of test 18. The supply is checked first.
The sheet's display column says yes, so the washer warns you.
For H2/B2, the model and whether other electronics at home are behaving strangely.
Codes, symptoms, parts and service
H3 or B3 is listed as supply voltage too high, the same wording as H2/B2, on Electrolux's 2018 washer sheet. The display shows it. Unplug the washer and book a technician; test 18 checks the supply under load first.
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.