Start from the symptom
Electrolux washer detergent dispenser problems.
Dispenser trouble on an Electrolux front loader usually comes from the wrong detergent, too much of it, a drawer that is not seated or buildup in the compartments. Detergent packs belong in the drum, not the drawer.

Start with safe observations.
Power the appliance down and pull the plug before any owner check. Beware of standing water and sharp debris. Never touch a wet plug or electrical area, take off service panels, or step beyond your model’s owner guide.
- 1
Use high efficiency detergent
Electrolux's detergent guide calls for high efficiency detergent, formulated to hold down suds. Liquid or powder goes in the main wash compartment, and it should stay under the maximum fill line.
- 2
Keep packs out of the drawer
Place a detergent pack in the drum before the laundry. Electrolux warns that the gel coating can clog the dispenser door.
- 3
Bleach and softener
Liquid bleach and fabric softener go in the compartments labeled for them.
- 4
Seat the drawer
If water spills from the drawer, make sure it is on its guide rails and closed all the way, flush with the front, and that the compartments are fully seated.
- 5
Water pressure and level
The leak article says high water pressure can contribute and suggests turning the faucet down to about half. Check that the washer is level, too.
- 6
Clean the buildup
Residue in the drawer can make it leak. The use and care manual has the cleaning steps for your model.
- 7
Suds messages
SU dS means too many suds were detected. The washer adds rinses, each about 5 minutes. Use less high efficiency detergent and run an empty quick wash. EF2 on the sheet reads too much soap or the wrong type.
Systems a technician may investigate.
The linked parts are the ones Electrolux’s technician sheets name for this appliance. We confirm each against your model number once the diagnostic is done, and you approve any replacement first.

Washer pressure sensor
The pressure sensor tells the washer how high the water stands in the tub. Electrolux’s washer sheet ties it to E13, E31, E32 and E35. E35 means the sensor reports an overfill; E31 and E32 point at the sensor’s own reading or calibration.

Washer door lock
The door lock keeps the washer closed during a cycle and tells the control the door is shut. Electrolux’s sheet lists five door codes. E41 means the board thinks the door switch is open; E42 and E43 are about the lock itself; E44 and E45 about sensing.

Washer drain pump
The drain pump clears water from the tub. Electrolux’s washer sheet ties E21, E23 and E24 to it: water that pumps out too slowly, and errors in the board’s switching or sensing of the pump. The sheet points them all to one test.
If the display adds a code.
Suds
SU dS means the washer detected too many suds and will run extra rinses until they clear, about 5 minutes each. Use high-efficiency detergent, use less of it, and run an empty quick wash to clean the unit. Press Cancel to clear the alert.
Suds
EF2 is how owners write F2, the washer sheet's too much soap or wrong detergent type code. No Electrolux document prints it with an E. Use less detergent, make sure it is high efficiency, and run a rinse. The display shows it.
Read the related care guide.

Washer stopped, nothing on the display? Recall the code.
An Electrolux front-load washer shows only some codes. To read the last stored one, power on, wait at least 10 seconds, then hold temp and select for 3 seconds. The display shows the last error in memory. Hidden codes include E13, E23, E31 and E62, and they need a technician.

Detergent left in the drawer? Check the product, the packs and the water.
Electrolux's written sources name no single cause for a drawer that stays full. They list what interferes: a pack in the drawer, detergent above the max fill line, an unseated drawer, buildup, and water that never arrives. Work through these, then book a technician.
When observation becomes a service request.
Leave internal testing to a technician.
Book a visit if the drawer is clean and seated, you use the right amount of detergent, and the dispenser still leaks, stays full or does not draw water. Tell us the model and describe which compartment is affected.
Arrange a diagnosticSources and model boundaries.
These sources back the Electrolux washer detergent dispenser problems guidance. Use the manual for your own model.
- Laundry Washers - Detergent Guide (KB 1834689)
- Laundry front loading washer is leaking water. (KB 1831358)
- Laundry front loading washer displaying Error Code SU dS too many suds. (KB 1829292)
- Washer Tech Data Sheet, A11200302 (1803)
Follow the guide for your exact model. Consult how we research these pages.
Can I put a detergent pack in the drawer?
No. Electrolux says to place the pack in the drum before the clothes, because the gel coating can clog the detergent door.
Which detergent should I use?
High efficiency detergent. Electrolux says it is formulated to reduce suds. Stay below the maximum fill line in the main wash compartment.
Why is my dispenser drawer leaking?
Electrolux lists a drawer that is not on its rails or not closed, compartments not seated, a washer out of level, high water pressure and buildup in the drawer.
What does SU dS mean?
The washer found too many suds. It will keep rinsing until they clear, adding about 5 minutes per extra rinse. Cut the detergent and run an empty quick wash afterward.
Codes, symptoms, parts and service
Link the message to what to do next.
SU dS
SU dS means the washer detected too many suds and will run extra rinses until they clear, about 5 minutes each. Use high-efficiency detergent, use less of it, and run an empty quick wash to clean the unit. Press Cancel to clear the alert.
Electrolux washer not spinning
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
Washer repair
Book a diagnostic for your model at the appliance.
Find your metro
Office details and the access information to pass on.