What it means
E73 means the inlet control thermistor is open circuit, per Electrolux's dryer chart. A technician checks its resistance, which should be 47K to 66K ohms at room temperature, and the wiring. Book a visit.
Electrolux dryer E73 / Sensors
E73 means the inlet control thermistor is open circuit, per Electrolux's dryer chart. A technician checks its resistance, which should be 47K to 66K ohms at room temperature, and the wiring. Book a visit.
Also shown as E73
E73 means the inlet control thermistor is open circuit, per Electrolux's dryer chart. A technician checks its resistance, which should be 47K to 66K ohms at room temperature, and the wiring. Book a visit.
Does the dryer run cool, end cycles early or take longer?
E73 returns.
Your checklist, kept on this device

Does the dryer run cool, end cycles early or take longer? The inlet thermistor reports the air entering the drum.

Rule out no-heat settings such as Air Fluff first.

Pulling or bending the sensor wire can damage it, so leave the connector for the technician to test.

Wake with any button except Cancel and hold Cancel and Start/Pause for 6 seconds.

The chart measures the thermistor against 47K to 66K ohms and replaces it and/or its wiring.
Send us the model and the checks you have done, and open your request here.
Book a visit


A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.

Component reference
Control thermistors are the temperature sensors that tell the dryer how hot the air is.
Read the definitionThe inlet control thermistor reads as open. The chart lists the thermistor or its wiring as defective.
Read the supporting manualThe inlet thermistor is a different part. The chart gives 47K to 66K ohms for it and 4.9K to 6.2K ohms for the outlet one.
Read the supporting manualResistance check, wiring check for an open, then replacement of the thermistor and/or wiring and a retest.
Read the supporting manualEF1 includes the inlet thermistor among its causes. If EF1 and E73 both appear, tell the technician.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
P/N 137265000B (1202); Canadian SKU EIMED6CJIW; original file dated 2009 / sheet p.2 (Error Code Chart)
Row E73 of the dryer chart, page 2.
A temperature sensor on the heated air entering the drum.
No. E74 is the same inlet thermistor reading as a short circuit. E73 reads it as open. Both use the same resistance range and fix.
Only if it dries normally; a sensor reading open may not limit heat correctly.
For E73, the model number and whether the dryer heats normally, runs cool or ends cycles early.
Codes, symptoms, parts and service
E74 means the inlet control thermistor is shorted, per Electrolux's dryer chart. A technician checks its resistance, which should be 47K to 66K ohms at room temperature, and the wiring for a short. Book a visit.
Most dryer noise has a simple source: coins or buckles in the drum, a loose pedestal, shipping bolts still in place or a dryer that is out of level. Electrolux also lists sounds that are normal, such as the chime at the end of a cycle.
Control thermistors are the temperature sensors that tell the dryer how hot the air is. Electrolux’s sheet names an outlet, an inlet and an exhaust thermistor. E71 to E74 mean an open or shorted sensor circuit, and EF1 and EF3 list them among the causes.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.