Model-specific code library
Electrolux dryer Power supply codes
6 printed codes in this group: EA1, EA2, EA3, EA4, EA5, H2 / B2.

Power supply codes
EA1 means the main supply frequency is out of range, per Electrolux's dryer chart. The conditions are line frequency outside limits or a faulty control board, and the chart's step is to check the line frequency. Unplug the dryer and book a technician.
Model-dependent / read firstEA2 means the line voltage is too high, per Electrolux's dryer chart. The conditions are high line voltage or a faulty control board, and the chart's step is to check the amplitude of the line voltage. Unplug the dryer and book a technician.
Model-dependent / read firstEA3 means the line voltage is too low, per Electrolux's dryer chart. The conditions are low line voltage or a faulty control board, and the chart's step is to check the amplitude of the line voltage. Do not use an extension cord; book a technician.
Model-dependent / read firstEA4 means improper home wiring, per Electrolux's dryer chart: the L1, N and L2 conductors may be wired incorrectly at the terminal block. The chart's step is to check the wiring there. This is installer or electrician work; book a technician.
Model-dependent / read firstEA5 is a main voltage sensing failure on Electrolux's dryer chart. The only listed condition is a defective electronic control board, and the solution is to replace it. Book a technician.
TechnicianH2 or B2 is a power supply issue in Electrolux's Owner Center dryer guide, which says to contact the electric company. Stop using the dryer, check the plug, outlet and breakers, and book a visit if the supply is normal.
Model-dependent / read first