Model-specific code library
Electrolux dryer Heating codes
7 printed codes in this group: E61, E63, E64, E65, E66, E67, NO GAS.

Heating codes
E61 is a heater relay failure on Electrolux's dryer chart: a heater relay is stuck open or closed, or the wiring is defective. If the dryer runs without heat, or heats when it should not, unplug it and book a technician.
TechnicianE63 is a heater to earth ground failure on Electrolux's dryer chart: the heating element or its wiring is shorted to the cabinet. Unplug the dryer and do not run it again until a technician has checked the heater.
TechnicianE64 is an open circuit in the heater on Electrolux's dryer chart: the heating element or its wiring is defective. The dryer may tumble with no heat. Check the cycle and the breakers, then book a technician.
TechnicianE65 means the high limit thermostat has tripped too many times, per Electrolux's dryer chart. The chart lists a restricted vent first, then the thermostat or, on electric models, the inlet thermal limiter. Clean the lint screen and vent, then book a technician.
Owner checks firstE66 means a thermal limiter is open on Electrolux's dryer chart: the outlet limiter has tripped, or on gas models the inlet limiter, or the wiring is defective. Unplug the dryer and book a technician; do not bridge the limiter.
TechnicianE67 is a heaters sensing failure on Electrolux's dryer chart. The chart lists one condition, a defective electronic control board, and one solution: replace it and retest. Book a technician.
TechnicianNO GAS on an Electrolux gas dryer means the install cycle found no gas connection, or a closed gas valve. A gas smell overrides everything below: get out first. Otherwise open the supply valve, check the line is connected, then run the install cycle again.
Check, then book