What it means
F6 is a control reset on Electrolux's 2018 washer sheet. The display does not show F6. The sheet says to check the wiring to the main board and to unplug the unit for one minute and retry. If F6 returns, book a technician.
Electrolux washer F6 / Control board
F6 is a control reset on Electrolux's 2018 washer sheet. The display does not show F6. The sheet says to check the wiring to the main board and to unplug the unit for one minute and retry. If F6 returns, book a technician.
Also shown as F6
F6 is a control reset on Electrolux's 2018 washer sheet. The display does not show F6. The sheet says to check the wiring to the main board and to unplug the unit for one minute and retry. If F6 returns, book a technician.
The sheet's own step for F6: unplug the unit for 1 minute and retry.
F6 returns after the one-minute unplug.
Your checklist, kept on this device

The sheet's own step for F6: unplug the unit for 1 minute and retry. Count the minute, then plug in and run a short cycle.

A loose plug can reset the control mid-cycle. Make sure it sits firmly in the outlet and that no extension cord is used.

Did the lights flicker or a breaker trip around the reset? Brownouts can reset the main board.

Wiring to the main board is for a technician, even though the sheet mentions it.

If the reset repeats, the sheet replaces the main control after the wiring check.
Send us the model and the checks you have done, and open your request here.
Book a visit

A simplified drawing, since layouts differ between models. Pick an outlined part for its photo and the related check.
The main control restarted itself. The sheet's wording is control reset, with no display notification.
Read the supporting manualTest 19: check the wiring to the main board, unplug the unit for 1 minute and retry; if the problem is not corrected, replace the main control.
Read the supporting manualA weak outlet or heavy shared circuit can reset electronics. Plug the washer in alone to rule it out.
Read the supporting manualA single reset is not. A repeated one means the control cannot be trusted mid-cycle.
Read the supporting manualManufacturer document
Electrolux (technician sheet; retailer-hosted copy)
A11200302 (1803); 2018, 300/400/500/600 series (EFLS527UTT and EFLS627UTT copies are byte-identical) / p.2 (Washer Error Codes)
Row F6 of the washer sheet: stored only. Test 19.
No. It concerns the control board restarting, which is separate from the water rows.
Yes, it is the sheet's own step and also the simplest. A full minute lets the board fully discharge.
No. For F6 the sheet's display column says no, so a cycle that stalls or restarts is the usual sign, and the stored error confirms it.
For F6, the model number and whether any power events or flickering lights happened at the time.
Codes, symptoms, parts and service
A washer that will not spin is most often reacting to an unbalanced or heavy load, a machine that is out of level, or a door that is not locked. Electrolux's sheet ties the motor-speed codes E55 and E59 to the motor, belt, tub bearings and motor control board.
Book a diagnostic for your model at the appliance.
Office details and the access information to pass on.